Connecting Two RV Propane Tanks for Manual or Automatic Changeover Between Tanks  

Since you're trying to do a decently large run you'd need to get two single stage regulators like JR Products High Pressure RV LP Gas Regulator #37207-30325 and connect them inline close to the tanks and then run them out to the Dual…

The bearings your Lippert 5,200 lb axle has are part #LM67048 and #25580 and the grease seal is #RG06-070. For a cotter pin you'd need just the #165649.

Thanks for the pictures of the axle information! Based on the information you provided your axle uses the following components: Inner bearing #25580 Inner race #25520 Outer bearing #LM67048 Outer race #LM67010 Grease Seal #GS-2250DL All of these…

In order to connect two 20 lb propane tanks to one another you are going to need a regulator with an auto changeover feature like the Camco Automatic Changeover 2-Stage Propane Regulator part #CAM59005. This regulator will pull from one tank until…

The Progressive Dynamics Inteli-Power RV Converter and Battery Charger #PD9160ALV will work great to charge your 80 amp hour Lithium battery with your Honda 2000 generator. Going with a higher rated charger would be a bit overkill for your battery…

Yes, the #100019-24 pigtail can be used to connect your dual-cylinder 100 lb propane setup to the regulator on your RV. Since this hose does not have a back-check to contain a gas leak, you will need the #204120-MBS fitting that includes a…

You can absolutely replace your Goodyear ST225/75R15 tires with the Karrier ST225/75R15 Radial Trailer Tire #AM10303. These tires will be exactly the same size and the load range E of the Karrier will give you a maximum capacity of 2,830 lbs at 80…

You can pretty easily go from a 205/75-14 to a 15 inch tire size like 205/75-15 like with the #AM32395 without clearance issues. This will give you a slightly larger wheel and tire which will have a higher weight capacity. So you might gain a slight…

The Mighty Cord Detachable RV Power Cord - 50 Amps - 25' #A10-5025EDBK is the shortest 50 amp cord available. We do not have a 10 foot length available, however, I do have another option for you. You can use the Mighty Cord 10' RV Power Cord…

After you've packed the bearings and assembled everything, carefully slide the hub assembly onto the spindle and install the outer bearing. Install the spindle and tang washer and run the spindle nut down finger tight, then rotate the hub back…

You can verify that the 10-19 grease seal included in Bearing Kit #BK2-100 is the correct one for your spindles by taking two measurements. First you want to measure the rear hub bore where the seal is inserted. The seal's outer diameter needs to…

The Cyclone part #CAM40595 is designed to mount to 1-1/2 inch diameter pipes. If that is what you have on your trailer this would work well. If you need something bigger the solar paneled #UF53-945001 would be a great option as well.