Recommended Truck Camper Cover for a Camper Measuring 171" L x 85" H

Question

Question:

need cover for popup truck camper length across top 171 inch w 85 inch h 68 inch bed length 89 +6 inch for jacks. Good for winter weather.

asked by: Thomas K

0

Expert Reply:

For your application I recommend going with the Adco SFS AquaShed Cover # 290-12262. This measures 192" long x 104" wide x 104" tall so it will fit your camper and it has straps and buckles on the bottom to secure it to your camper.

This cover is built to withstand climates with high moisture so it will work well during the winter months with snow. I do recommend using the Mini Dehumidifier # CAM44195 as well though to keep the inside of your camper smelling fresh!

expert reply by: Jon G

0

Answer 1

Thanks for reaching out about this product. The Camco UltraGuard Slide-In Camper Cover - 16-1/2' Long #CAM45771 does have integrated zippers to help you access your truck camper. However they are on the corners and, to me, seem to be more of a…

view full answer...

Answer 2

Hey David, from previous customers of ours who have the same 2020 Keystone Raptor 424 we have determined that your pin box style is the Lippert 1621 which means for a Gen-Y gooseneck adapter you'd want the #GY58GR that you referenced.

view full answer...

Answer 3

When measuring for a trailer cover you want to measure from the front of the trailer box, not the tongue, to the rear including anything that is attached to the rear. This will include a spare or a ladder at the farthest edge at the rear of the…

view full answer...

Answer 4

The Adco SFS AquaShed Truck Camper Cover part #290-12264 is what I recommend for your Lance Truck Bed Camper Model 1010. The Adco SFS AquaShed is durable, has zippered panels for access inside, and has weighted buckles to help with installation. The…

view full answer...

Answer 5

The Demco Channel Only Trailer Actuator, part #DM8202022, was designed to be used with drum brake applications only. You could use this actuator with disc brakes, but you would have to replace the master cylinder in the actuator with the Demco disc…

view full answer...

Answer 6

If you are just looking for a new converter, the Replacement Converter for Parallax/Magnetek or WFCO RV Power Centers part #PD4635V will be a direct upgrade for the Magnetek Converter Series 6300 Model 6332 that you have now.

view full answer...

Answer 7

Trailer tires and wheels do not typically come balanced from the factory like what you see with standard passenger vehicle tires. This isn't usually needed for trailer tires and most car shops don't have the needed setup to properly balance…

view full answer...

Answer 8

Hi there David; we do have truck camper jacks that can work for your F-250 with a lift and large tires. What you can use are camper jacks from Brophy, which have a 17" to 67" lift range, which is the highest possible lift height. There are…

view full answer...

Answer 9

For the factory brake controller on your 2017 Chevy Silverado 1500, the factory brake controller will install to the same location as an aftermarket wiring harness like #3016. The black box to the left of your brake pedal is the location with the…

view full answer...

Answer 10

The Dexter 8-427 hub is no longer available. Even looking through Dexter's site the only references to it are replacement bearings. You can use a wheel with a larger pilot hole as long as the wheel attaches to the hub using lug nuts and not…

view full answer...

Recommended Truck Camper Cover for a Camper Measuring 171" L x 85" H

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching