Photo Showing 2007 Honda CR-V with EcoHitch Hidden Trailer Hitch Receiver 306-X7291 Installed

Question

Question:

Can you provide pictures?

asked by: Whitaker M

1

Helpful Expert Reply:

You can refer to the linked photo to see the installed appearance of the EcoHitch Hidden Trailer Hitch Receiver # 306-X7291. The hitch cross tube is mostly hidden behind the bumper cover to give a clean look on your 2007 Honda CR-V.

expert reply by: Adam R

1

click to enlarge

Answer 1

I have attached the installation instructions of the EcoHitch Hidden Trailer Hitch Receiver part #306-X7291 for a 2008 Honda CR-V to this answer page for you. In regards to installation, this is a bolt-on fit with a very clean finished install…

view full answer...

Answer 2

If ground clearance is your main concern the EcoHitch Hidden Trailer Hitch Receiver #306-X7291 is absolutely the best choice for your 2008 Honda CR-V. This is because unlike the other options available, which sit completely beneath the rear bumper,…

view full answer...

Answer 3

The Hidden EcoHitches like the part #306-X7291 that you referenced will be mostly out of sight when installed and not being used to tow a trailer.

view full answer...

Answer 4

The hitch opening of the EcoHitch #306-X7291 is not removable like some versions of the EcoHitch offer. For your 2011 Honda CR-V there are no options that have removable hitch openings but this hitch is about as hidden as it can be since only the…

view full answer...

Answer 5

A Class II hitch would use a 1-1/4 inch receiver, for a 2 inch receiver tube you'd want a Class III hitch. We offer two US Made Class III hitches that I'd recommend, the #13555 from Curt or the #306-X7291 from EcoHitch. Both hitches…

view full answer...

Answer 6

Getting the trailer as close to level as you have should be just fine. If your only options are to be a tiny bit too high or a tiny bit too low I usually recommend going on the high side since most likely the suspension will compress slightly from…

view full answer...

Answer 7

The EcoHitch Hidden Trailer Hitch Receiver part #306-X7291 which is a fit for a 2008 Honda CR-V does indeed require trimming of the rear bumper fascia but no drilling. I have attached a photo of the required trimming for you which as you can see is…

view full answer...

Answer 8

I'd be happy to help! All of the hitches for your 2011 Honda CR-V weigh relatively the same when it comes to the different classes, and while the Class I hitches definitely weight lighter I recommend using a Class III hitch since they have a…

view full answer...

Answer 9

The Draw-Tite Max-Frame Trailer Hitch Receiver - Custom Fit - Class III - 2", part #75547, will still be my recommendation. It has a maximum tongue weight of 675 lbs and a maximum gross tongue weight of 4,500 lbs, which is greater than the other…

view full answer...

Answer 10

I looked up the towing capacity for your 2007 Honda CR-V and it looks to be 1,500 lbs as the max capacity for the vehicle. I'm not sure if your trailer would weigh less than that but we do have everything you'd need to tow a trailer with your…

view full answer...

Answer 11

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 12

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Photo Showing 2007 Honda CR-V with EcoHitch Hidden Trailer Hitch Receiver 306-X7291 Installed

Product Page this Question was Asked From

Continue Researching