Installing New 4-Way Trailer Harness on Trailer When Old Wiring Had Wishbone for Running Lights
Question:
how exactly do you run a jumper wire to run all the lights on the trailer? My trailer had a wishbone plug and I have a regular 4 prong 4 wire plug to replace it.
asked by: BK
Expert Reply:
To replace your wishbone style wiring with the regular 4 way wiring that doesn't have that second running light wire, you will simply connect a wire like # 16-1-1 to the running light wire at the tail light, and then secure it to the trailer frame across the frame to the opposite side tail light to add that running light function.
The other option if there isn't a Crossmember in the frame to route that wire is to use a butt connector like # DW05744-5 to connect one end of the running light wire to and then run two wires out the other end to create a wishbone near the coupler or frame split from the pole tongue.
Products Referenced in This Question
Deka Heat Shrink Butt Connector - 16-14 Gauge - Nylon Insulation - Blue - Qty 5
- Wiring
- Wire Connectors
- Butt Connectors
- 16-14 Gauge
- Deka
more information >
Product Page this Question was Asked From
- Trailer Wiring
- Trailer Connectors
- Trailer End Connector
- 0 - 5 Feet Long
- Plug and Lead
- 4 Flat
- Draw-Tite
more information >
Continue Researching
- Q&A: Does The Draw-Tite trailer Hitch Receiver Come With One Or Two Hitch Pin Holes
- Q&A: Replacement Hub and Drum Assemblies for AL/KO 8460 Hubs and Drums
- Q&A: Replacement Zerk Fitting Recommendation for Dexter EZ Lube Spindle
- Article: Trailer Wiring Diagrams
- Q&A: Can 12 Volt Accessory Circuit of Trailer Wiring Keep 10 Amp Breakaway Battery Topped Off
- Q&A: Recommended Roof Rack Crossbars for Lance Cab Over Camper With Factory Tracks
- Q&A: Can You Install a 5th Wheel Hitch On a 2021 GMC Sierra 2500
- Q&A: 4-Way Trailer Connector that has 5 Wires
- Article: How to Measure for Trailer Hitch Drop
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
- Article: Trailer Tire Sizing
- Article: Brake Controller Installation: Starting from Scratch
- Article: Towing a Trailer? Let's Talk About Brake Controllers
- Article: Troubleshooting 4 and 5-Way Wiring Installations