Best Airbags for a Lowered 1987 Chevrolet R10

Question

Question:

I am unsure if this will work for my truck since it has been lowered by a previous owner. Since I am just keeping it as is I thought I could install these airbag helpers, but I want to make sure they will fit my truck. The truck was lowered at least 3 inches all around. Also, if it does fit what would be the maximum load? Thank you!

asked by: Jaime

1

Helpful Expert Reply:

In regards to the type of lowering kit that was installed on your 1987 Chevrolet R10, do you know if it was an axle flip kit installed (axle over leaf springs) or were lowering blocks/shackles used? If you have an axle flip kit then you are going to want to use the Air Lift SlamAir Air Helper Springs for Lowered Trucks part # AL59106BT but if you have lowering blocks/shackles then you will want to use the Air Lift SlamAir Air Helper Springs for Lowered Trucks part # AL59103. Though not specially mentioned via the fit guide, they will fit your R10 as confirmed by my contact at Air Lift.

They both have a 2,000 lb weight capacity.

expert reply by: Conner L

1

Answer 1

Thanks for the picture! I would definitely go with one of the HD kits over the 2,000 lbs RoadActive item #RAS3611 you were looking at. Which one you will need is going to depend on whether or not your 2020 Chevy Silverado 2500HD has the factory…

view full answer...

Answer 2

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 3

The two sizes you mentioned are pretty similar and fit many of the same 15 inch wheels. The 205/75-15 fits rim widths of 5 inch to 6-1/2 inch whereas the 225/75-15 fits widths that are 5 inch to 6 inch. The 205 is 27.1 inches tall and the 225 is 28.4…

view full answer...

Answer 4

The 40 amp fuse for your 2006 Chevrolet Silverado tow package is used for the 12 volt battery charge circuit. This fuse is located toward the front of the underhood fuse box closest to the front auxiliary positive post (see photo). There may be a…

view full answer...

Answer 5

On a 2005 Chevy Silverado 1500, If you are facing the front of the truck looking at the power distribution box, there will be a post at the back left side and a fuse slot near it. It is that fuse slot that you will install a 30 amp fuse. I have…

view full answer...

Answer 6

What you're going to need is two of the transfer switches in that case. I have attached a diagram from Furrion that shows you how you're going to need to hook the two transfer switches #F30ATS up: -one to the other, then one branching off to…

view full answer...

Answer 7

Since you have a wheelbase/axle spacing of 38 inches the correct hanger kit for slipper springs would be the part #HAP-105-205-01. And then for a 7k trailer axle the u-bolt kit you'd want would be the part #APUBR-8. I attached the diagram to use…

view full answer...

Answer 8

You will need the Red LED Trailer Clearance or Side Marker Light #328-K-52 or Amber LED Trailer Clearance or Side Marker Light #328-K-51 for your 2018 Forest River Sunseeker motorhome. These lenses have the same Top Command SAE-AP2-16 markings on the…

view full answer...

Answer 9

For your enclosed trailer application I have several suggestions for adding interior lighting that you can control directly via a switch. Since your current 4-pole trailer wiring does NOT include a 12V auxiliary power feed that could power inside…

view full answer...

Answer 10

The only way you could power interior dome lights on a trailer without it being connected to a tow vehicle would be to power the lights with a battery like a breakaway battery. How you choose to wire up the batteries will in the end be up to you, but…

view full answer...

Answer 11

We do have the Rhino-Rack Masterkey Lock Barrels #RRRK093-2 which will provide you with 2 new lock cores and keys for your Rhino-Rack Zenith MasterFit Rooftop Cargo Box #RRRMFZ66. As far as pricing goes on the different sets they can change based on…

view full answer...

Answer 12

The best option we offer for your dump trailer is the Erickson Mesh Tarp and Truck Bed Cover part #EM57059 which measures 12' wide x 16' long. It's not the exact dimensions you wanted but it will still cover most of the area you need it…

view full answer...

Best Airbags for a Lowered 1987 Chevrolet R10

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching