How Does the Marine 2-Position Battery Switch # 277-000403 Install

Question

Question:

how does it work

asked by: Roger G

0

Expert Reply:

Basically you use install the Marine 2-Position Battery Switch # 277-000403 by cutting the wire for the circuit you want to install it on and wire one end of the wiring to either post underneath the switch. When the switch is "on" the circuit is completed and when it's "off" the circuit is deactivated. I attached a picture that shows the underneath side of the switch with the posts visible.

expert reply by: Jameson C

0

click to enlarge

Answer 1

I have exactly what you are looking for, but the ease of install can be a bit of a loaded question. If you are comfortable dealing with trailer wires such as the occasional splicing or battery terminal connection, then this install will be easier…

view full answer...

Answer 2

Are you having issues with a MaxxAir MaxxFan roof vent like #MA00-04000K? It could be an internal issue with the fan and it needs to be replaced. Before replacing you can check a couple of things. Is it a new install? If so make sure you have the…

view full answer...

Answer 3

The most weather resistant battery disconnect switch we offer is the Marine 2-Position Battery Switch part #277-000403 which as the title states is a marine grade battery disconnect that holds an IP54 rating. That said, a battery disconnect switch is…

view full answer...

Answer 4

You can use the Marine Battery Switch #277-000403 for your application but since this item is not rated for outdoor use I recommend using a junction box like #3375601100 to provide a degree of protection from moisture. The switch housing (not…

view full answer...

Answer 5

There are two ways to wire up two batteries. One way doubles the volts of the two batteries and the other keeps the same amount of volts. In parallel the voltage stays the same and in series it is doubled. Check out the diagram for more info.

view full answer...

Answer 6

Yes, you will need to disconnect your 2024 Chevy Silverado 2500 battery when flat towing it. I recommend installing the Roadmaster Battery Charge Line Kit #RM-156-25 to provide a charge to your battery while traveling. This ensures you don't get…

view full answer...

Answer 7

To convert the WFCO WF-8955PEC to be lithium compatible you'd need the part #PD4655V and you'd be set. This fits in the panel without any modifications.

view full answer...

Answer 8

The Curt Spectrum Trailer Brake Controller part #C51170 will illuminate even without a trailer connected that is correct. If you don't wish to see this light each time you hitch the brakes without a trailer attached then you will either need to…

view full answer...

Answer 9

The TorkLift PowerArmor Solar Locking Battery Box part #TLA7700LS is not wide enough to fit two group 31 batteries. Group 31 batteries are 13" long by 6.72" wide by 9.44" tall. The only option that's big enough is the Commercial…

view full answer...

Answer 10

The etrailer Classic Base Plate Kit #e98968 for your 2011 Ford Fiesta will need an Adapter #e98982 to work with the Blue Ox Aladdin, Aventa II, Aventa LX, or Alexus tow bars. While we do not have a installation video for these I have linked the…

view full answer...

Answer 11

All of the Redline Locking Stainless Steel Flush Door Latch, part #L1833, are keyed the same, so if you ordered two they would be the keyed the exact same already.

view full answer...

How Does the Marine 2-Position Battery Switch # 277-000403 Install

Continue Researching