Why Would New Trailer with New Generators Not Power On When Connected

Question

Question:

I have a 2019 Reflection by Gramd design 5th whew, it has a 50amp system, I have 2 A-ipower generators running parallel. It will not power up my RV. Any ideas why? I have the 50to 30 amp connector. And nothin. Any help would be appreciated.

asked by: Mark

0

Expert Reply:

Are there any breakers or switching on your 2019 Reflection by Grand design 5th wheel that need to be switched on? A lot of cmapers will have master switches to shut off all power which you might check for on your camper.

expert reply by: Jameson C

0

Answer 1

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 4

I'm happy to confirm that yes, the B&W Patriot 5th Wheel Trailer Hitch w/ Slider #BWRVK3270 with the B&W Universal Base Rails and Installation Kit for 5th Wheel Trailer Hitches #BWRVR3200, and the Draw-Tite 5th Wheel/Gooseneck Wiring…

view full answer...

Answer 5

As you may have already found, 5200 lb, 6000 lb and 7000 lb axles can all use the same components including inner/outer bearings, hubs and brakes. Here are some other things they share in common: Dexter 5200 lb Regular Duty Axle - 0.180 inch tube…

view full answer...

Answer 6

You did not mention if your 2013 Chevy Silverado was a 1500, 2500, or 3500 so I can provide recommendations for all 3. For a 1500 I recommend Curt trailer hitch #14301. There is no drilling or trimming required for installation of this hitch. I have…

view full answer...

Answer 7

Hi Jeremy; that's a good question and you'll actually need to go ahead and re-do the set up of your weight distribution system after adding the Timbren Rear Suspension Enhancement System #TDR1500DS to your 2019 Ram 1500. So it wouldn't…

view full answer...

Answer 8

Yes, the Camco Power Grip #CAM55025 will work if you plug in both the 30 amp male and 15 amp male into your generator.

view full answer...

Answer 9

The 15,000 Btu Furrion air conditioner is what I would recommend and what I have on my trailer. Since it is an enclosed trailer I'm guessing you want the manual distribution box. You can choose from the following based on color: -Furrion Chill HE…

view full answer...

Answer 10

I checked the install manual for the MORryde Wall RV TV Mount part #MR82ZR and there were no stipulations for mounting orientation but the location of the handle will change if you choose to mount it so it slides out to the left. That said, you…

view full answer...

Answer 11

I really like the Furrion Chill HE RV AC units like the 15k BTU part #FR32PR. We have found that the Furrion units blow the coldest and are the quietest. This kit comes with an air distribution panel and comes with everything needed to install.

view full answer...

Answer 12

I measured the Replacement Blades for AirrForce 42" Hugger Style RV Ceiling Fan #277-000398 for you and they are 16- 5/8 inches long with 4 inches wide at the bottom and 4-7/8 inches wide at the top. I've attached a photo to assist.

view full answer...

Why Would New Trailer with New Generators Not Power On When Connected

Product Page this Question was Asked From

Continue Researching