Remote Replacement Recommendation for Lippert Touchscreen Jack System

Question

Question:

I have 2015 Salem hemisphere 300bh travel trailer. It has electric Jacks not self leveling . The remote broke need to replace what do I need?

asked by: Mike

0

Expert Reply:

Thanks for the picture of your remote. Based on that we can tell that you need the Replacement Touchscreen Remote w/ Charger for Lippert Ground Control 3.0 Electric Leveling System # LC358601.

expert reply by: Jameson C

0

click to enlarge

Answer 1

The battery of the remote that comes with the #LC358601 is a Lithium-ion battery that is not replaceable. Since yours won't hold a charge only option is to replace it with the #LC358601. On the Lippert Ground Control leveling system using…

view full answer...

Answer 2

In order to sync the Replacement Touchscreen Remote part #LC358601 with the multi-function pad on your 2015 Keystone Cougar 327RES you are going to want to complete the following: 1) To begin syncing the remote to the receiver, both the receiver…

view full answer...

Answer 3

To re-configure the Touchscreen Remote #LC358601 for leveling with your Lippert Ground Control System you will just need to follow these steps outlined in the attached photo. Please just let me know if you continue to have issues and I will be…

view full answer...

Answer 4

Thank you for the extra information! In your previous question you stated that you had pressed the left button five times and then the right button five times but nothing happened. If you check out the attached clip from the instructions of the…

view full answer...

Answer 5

Lippert does have a remote that allows control of the slide outs as part #LC292614 but the part #LC358601 is for a system that does not control slide outs.

view full answer...

Answer 6

Yes the Replacement Touchscreen Remote w/ Charger #LC358601 is designed to work with either the 4-Point Lippert Ground Control System #LC358590 that you have, or the 6-Point #LC675817. The Control Module #LC304136 used on the 4-point system is what…

view full answer...

Answer 7

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 8

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13…

view full answer...

Answer 9

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 10

Load range B trailer tires are going to have a lower capacity than C load range tires. Basically that, psi rating, and the ply rating are the only differences. A higher load range tire would last a little longer than lower load ranges of the same…

view full answer...

Answer 11

The three most common lug stud sizes for a trailer are 1/2"-20, 9/16"-18, and 5/8"-18. In order to make sure you get the correct lug nuts you need to measure the lug studs on the trailer now as we have no way to look this…

view full answer...

Answer 12

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Remote Replacement Recommendation for Lippert Touchscreen Jack System

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching