3 Step RV Step Replacement Solution for Brackets 25-1/2 inches in Width

Question

Question:

I am in search of a replacement 3 step for my travel trailer. The exact size in between the current mounting brackets is 25.5”. I am having a tough time finding a replacement with that measurement. Are you able to help? Thanks

asked by: Mark

0

Expert Reply:

All of the triple steps we offer like the part # LC432687 that you referenced are 27 inches in width. If you need a triple step you would need to have the mounting brackets on your trailer moved to accommodate these steps.

Any qualified fabricator in your area should have no problem moving the mounting brackets to allow the steps to install. Or for a new set of mounts you could use the Outriggers part # LC301704.

expert reply by: Jameson C

0

Answer 1

I spoke with the manufacturer to ensure the measurements were correct and found that the chart on the page for #LC432690 is incorrect. It does require 27-1/2" of space for the mounting brackets. Both the #LC432690 and #LC432696 will be too big…

view full answer...

Answer 2

The GCH6A-10E is a 6 gallon water heater so you could replace it with the Dometic RV Water Heater - Gas and Electric - Automatic Pilot - 120 Volt - 10,000 Btu - 6 Gal Tank #DMC74FR but I highly recommend swapping from a standard RV water heater to a…

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

To change the battery mode on the Progressive Dynamics 9300 Series RV Converter Charger #PD79RR you'll need to insert the included CLAW tool into the small opening next to the battery type indicator light. Press and hold that button (using the…

view full answer...

Answer 5

Hey Phil, the correct 60 amp converter replacement that is Lithium compatible is the Progressive Dynamics part #PD79RR. This charges at the higher voltage required by lithium batteries.

view full answer...

Answer 6

The difference between the two models that you were researching is that the #PD9160A is designed for use with lead acid batteries and the #PD9160ALV is designed for use with lithium batteries. Choosing the incorrect battery profile can lead to issues…

view full answer...

Answer 7

To replace your converter you have two options: Option 1: Completely replace the converter and AC/DC distribution panel. You could use a power center like the #PD4135K or a larger one if you'd like a higher amperage converter and more AC circuit…

view full answer...

Answer 8

Hey Dave, for a 60 amp charger the 6-gauge wire that you have currently is not going to cut it. You will want to use 4-gauge copper wire for your 15' run when using the Progressive Dynamics PD9200 Series Battery Converter Charger #PD9260C. For a…

view full answer...

3 Step RV Step Replacement Solution for Brackets 25-1/2 inches in Width

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching