Is the Bolt-Together Round Bar Head a Replacement for 2 Sway Ball Setup For 10,000lb Hitch?

Question:

I have a older setup and I just need to replace the hitch for one that has 2 sway ball setup for 10,000lb hitch is this the one I need?

asked by: Dominic S

Expert Reply:

The sway control ball on the Replacement Weight Distribution Bolt-Together Round Bar Head # PS58442 can be used with two balls and you can use the balls on either side of the head assembly (see picture).

This replacement head fits Pro Series weight distribution systems # PS49583, # PS49582, # PS49901

The adjustable shank # C17100 is not included with this product, but it does come with the bolts, the nuts and the washers to get that installed and attached to the weight distribution shank. Its also comes with a hitch pin and clip. This is to secure the weight distribution shank inside the receiver tip of your hitch. Its going to come with two other clips. These are for the frame brackets or lift brackets.

For an additional hitch ball with a 2 inch diameter and a 1-1/4 inch diameter shank i recommend part # A-90. If you need a 2-5/16" Hitch Ball with a 1-1/4" Diameter, I recommend # 63840.

Since you are going to use this head with 2 sway bars, you will need (2) Curt Sway Control Hitch Ball # C40093.

In order to make sure this unit works with your system, can you tell me what type of system you have? If you can send me a picture of the system that will help also.

expert reply by: Timothy G

click to enlarge

Laverne S.

5/29/2020

I have a new Curt hitch don't know how to take off the round bars off the hitch when unhooking trailer from truck and also is there a problem with ii when backing up the trailer, Thanks

Chris R.

6/2/2020

There's a tab above each attachment point on the head that needs to be pushed for the spring bar to drop freely. I wouldn't try backing up with the system attached - you'll want to at least disconnect the sway bar before doing so.