Recommended LED Strip Lighting for Trailer Sides

Question

Question:

We have 3 mobile units 32 ft. long each and would like to run bright LED strips down left and right sides. There is a roof overhang we would mount to pointing the lights down the side of the trailer. Were looking for sections about a yard long or so that could quickly be replaced when one would stop working. The unit has 24 volts and wed put a plug-in on the wall at each strip section. Can you help us?

asked by: Ron P

0

Expert Reply:

The best option we have for what you are looking to do is the Thinline Opti-Brite LED Interior Strip Light - 21-7/8" Long x 1" Wide x 5/8" Thick # ILL72CB if you are looking to light the inside of the trailer. If you are wanting to light the outside, then I recommend the Ultra-Thin-Line LED Utility Light Bar - 11 Diode - Sealed - Rectangular - White w/ Clear Lens # BUL69CB. If you want the chrome base, you can use # A69CB with these lights.

expert reply by: Jason S

0

Answer 1

The #BUL69CB LED Utility Light Bar you mentioned can be used for utility use or general illumination, but is not certified by the DOT for use as a back-up lamp as it would be too bright.

view full answer...

Answer 2

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 3

The only difference between the Optronics ThinLine LED Trailer Tail Light part #STL87RCB and part #STL87RCPG is that the latter has bullet style (removable) connectors and the former has bare wire ends.

view full answer...

Answer 4

Yes, because it is a 3-wire light, you can wire the Red Identification Light Bar with White LED Utility Light #OPT88FR to function as rear marker and reverse lights.

view full answer...

Answer 5

The Optronics ThinLine LED Trailer Tail Light part #STL87RCB is a tail light but if you were instead installing the light to act as a marker light which would be its intended purpose if installed in the center of the trailer then you'd simply…

view full answer...

Answer 6

Polar does not actually list a weight rating for their T-Strap Hinge for Enclosed Trailers #PLR3408-SS but both the bracket and strap are made from 8 gauge 304 stainless steel which is going to be plenty strong and work just fine with your toy…

view full answer...

Answer 7

I spoke with JR Products about the Replacement RV Bottom Wardrobe Door Guide #37220585, and they said to reinstall these guides you'll just need to snap the bottom guides into place the same manner as the top rollers. I've attached the…

view full answer...

Answer 8

The reverse light pin on a traditional 7-way trailer connector, like part #PK11893 or a factory connector if that's what you have on your 2018 Ram, is the center pin. Take a look at the picture I attached that shows all the pin functions. To add…

view full answer...

Recommended LED Strip Lighting for Trailer Sides

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching