Can 4-Way Trailer Wiring have 7 Wires Ran to It
Question:
Help I have a Karavan watercraft trailer 2005. I am looking for trailer end connector 4 pole flat with seven with 7 wires??
asked by: S
0
Expert Reply:
Sounds like each of the taillight circuits on your 4-way have a two wires ran to them for each side of the trailers wiring. This is pretty common and what you can do is wire the two wires of each pin to the single wires of a new 4-way like the # W787264. That will allow all of the same circuits to get the same signal.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Wesbar 4-Pole Flat Connector w/ Jacketed Cable - Trailer End - 4' Long
- Trailer Wiring
- Trailer Connectors
- Trailer End Connector
- 0 - 5 Feet Long
- Plug and Lead
- 4 Flat
- Wesbar
more information >
Continue Researching
- Article: What To Look For When Buying Ratchet Straps
- Q&A: What Gauge Wire does 4-Way Trailer Wiring Use
- Q&A: Correct B&W Turnoverball Underbed Gooseneck Trailer Hitch for 2019 Ram 2500 Without Prep
- Article: Gooseneck to 5th Wheel Adapters
- Article: Trailer Wiring Diagrams
- Q&A: How To Install the Spindle Nut on a 12,000 Pound Dexter Axle
- Q&A: Replacing A Dexter Axle With Higher Load Rating Dexter Axle
- Q&A: Is ST225/75D15 Bias Trailer Tire w/15 White Mod Wheel 5 on 4-1/2 Load Range D Balanced
- Q&A: Tire/Wheel Combo Needed that is Rated for 3,500 lbs and Compatible with Dexter # 35545E-ST-89
- Q&A: Can Larger Tires be Used on a Trailer if there is Clearance for the Bigger Size
- Article: How to Accurately Measure Trailer Leaf Springs
- Article: Wiring Trailer Lights with a 6-Way Plug (It's Easier Than You Think)
- Article: Trailer Lighting Requirements
- Article: Printable Trailer Bolt Hole Pattern Template