Does Installing Camco RV Vinyl Trim Insert part # CAM25272 Require Sealant

Question

Question:

ONCE I REPLACE WITH NEW TRIM THAT GOES ALONG THE LENGTH OF MY MOTORHOME ON THE SIDE, INTO A TRACK,DO I NEED TO BUT A SEALANT WHERE THE NEW TRIM GOES INTO THE TRACK?? THANKS

asked by: Mark R

0

Expert Reply:

You do not need to use any type of sealant to install Camco RV Vinyl Trim Insert part # CAM25272 that you referenced.

expert reply by: Jameson C

0

Answer 1

Is your truck a newer GM truck by chance?

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 4

If you are just looking for a new converter, the Replacement Converter for Parallax/Magnetek or WFCO RV Power Centers part #PD4635V will be a direct upgrade for the Magnetek Converter Series 6300 Model 6332 that you have now.

view full answer...

Answer 5

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...

Answer 6

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 7

You do not have to use a sliding 5th wheel hitch in a short bed truck. In many cases, truck beds shorter than 8 ft do not have enough clearance between the trailer and truck to execute sharp turns. This is why sliding hitches were invented. Due to…

view full answer...

Answer 8

Yes, you can install a Curt Trailer Hitch Receiver #C11433 on your 2019 Chevrolet Spark. This receiver is capable of supporting up to 200lbs of tongue weight. With each of the Lectric 3.0 e-bikes weighing roughly 60lbs without the battery you will…

view full answer...

Answer 9

We sure do! It looks like your TAB 320 S Tear Drop Camper tops out a 3,000 lbs which would give it a tongue weight range somewhere around 300 lbs depending on how you load it. For a surge brake compatible weight distribution system, I recommend the…

view full answer...

Answer 10

I recommend the Roadmaster Dual Hitch Receiver Adapter, 10" Drop/Rise item #RM-077-10. This adapter was designed for this type of set up. Your Jeep Rubicon and Swagman E bike rack weigh well below the 10,000 lbs maximum capacity of this hitch. I…

view full answer...

Does Installing Camco RV Vinyl Trim Insert part # CAM25272 Require Sealant

Product Page this Question was Asked From

Continue Researching