What Parts are Needed to Tow a Trailer with a 2005 Honda Pilot
Question:
I recently purchased a 2005 Coleman Pop up and need to install a hitch on my 2005 Honda Pilot. Can you provide all the materials I need so that I can make sure I have the correct set up?
asked by: Eric B
Expert Reply:
We certainly do have everything you need to get your 2005 Honda Pilot ready to tow a trailer. To start with I recommend the Draw-Tite trailer hitch receiver, part # 75599. It's a custom fit on your Pilot and I've attached an install video for you.
You also need a ball mount, hitch pin, and hitch ball. We have a kit that includes several options of them all, part # 989900. First you need to determine the drop or rise you need with your trailer. I've linked an article to help with this as well. In the video of the hitch being installed you can see that it was 17 inches from the ground to the top of the receiver tube when we measured it. Compare this to the bottom of your trailer's coupler's height.
Finally, the Pilot needs a trailer wiring harness to power the trailer's lights. Part # 118336 plugs right in to a connector in the rear cargo area. You need to temporarily remove some paneling. I've linked this install video as well.
In addition to the articles and videos I mentioned there are a few general ones on towing you might take a look at too.
Products Referenced in This Question
T-One Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- Converter
- Custom Fit
- 4 Flat
- Tekonsha
more information >
etrailer Ball Mount Kit for 2" Hitches - 7,500 lbs
- Trailer Hitch Ball Mount
- Fixed Ball Mount
- 1-7/8 Inch Ball
- 2 Inch Ball
- Two Balls
- Steel Ball
- Steel Shank - Gloss Black
- Drop - 2 Inch
- Drop - 4 Inch
- Rise - 1 Inch
- Rise - 3 Inch
- Fits 2 Inch Hitch
- 7500 lbs GTW
- Class III
- Ball Mount Kit
- etrailer
more information >
Product Page this Question was Asked From
Draw-Tite Max-Frame Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Trailer Hitch
- Custom Fit Hitch
- Class III
- 350 lbs TW
- 3500 lbs GTW
- 5000 lbs WD GTW
- 2 Inch Hitch
- 500 lbs WD TW
- Concealed Cross Tube
- Draw-Tite
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Towing Capacity of 2005 Honda Pilot and Parts Needed to Tow Trailer
- Article: How to Measure for Trailer Hitch Drop
- Q&A: Parts Needed to Tow a Trailer with a 2007 Honda Pilot
- Q&A: Trailer Hitch Recommendation for 2003 Honda Pilot
- Article: How to Choose the Right Trailer Hitch Class
- Q&A: Trailer Hitch for a 2006 Honda Pilot w/ Full Size Spare
- Q&A: Hardware for Curt Class III Trailer Hitch Receiver # 13328 to fit a 2005 Honda Pilot
- Article: 5 Things to Know About Weight Distribution Hitches
- Q&A: Does a Short Bed Truck Need a Slider if the Trailer has Max Turn Technology
- Q&A: New Trailer Hitch Is Touching Exhaust On 2005 Acura MDX
- Article: My Trailer Hitch Doesn't Fit
- Article: How to Clean Weld Nuts for the Installation of a Trailer Hitch | etrailer.com
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Rolling on a Budget: Top Wallet-Friendly Platform Bike Racks