Can a Winch be Mounted to Bulldog Winch Grille Guard # BDW733644B

Question

Question:

Can winch mount to brush guard?

asked by: Philip W

0

Expert Reply:

To use a winch with Bulldog grille guard # BDW733644B you will also need a winch carrier like the # BDW733601 for 12K winches that is a confirmed fit for this guard.

expert reply by: Michael H

0

Answer 1

I attached a photo that shows the bolt layout on the mounting brackets for Winch Carrier for Bulldog Winch Grille Guard - 12,000 lbs #BDW733601. The bottom two bolts are 3-1/8" apart, while the top and bottom bolts (parallel to each other)…

view full answer...

Answer 2

The Winch Carrier for Bulldog Winch Grille Guard - 12,000 lbs #BDW733601 is not a fit for your 2000 Ram 3500. The only mount that is available is a receiver mount like the Bulldog Winch Receiver Mount Kit - 2" x 2" #BDW20155 or the…

view full answer...

Answer 3

The manual lockout on your Atwood 85778 surge brake coupler is there so that you can back up the trailer without the brakes locking up on you. Yes you can safely tow your trailer with the broken manual lockout, you just have to make sure you…

view full answer...

Answer 4

If your old axles have a 5 bolt brake flange the assemblies like Dexter Electric Trailer Brake Assembly - 12" - Left Hand - 6,000 lbs part #23-105 or Dexter Electric Trailer Brake Assembly - 12" - Right Hand - 6,000 lbs part #23-106 will…

view full answer...

Answer 5

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 6

Below is the general process for bleeding an electric over hydraulic brake actuator like #K71-650. Fill reservoir with NEW brake fluid. Never re-use brake fluid that has been salvaged or removed from another system. Remove the key from the breakaway…

view full answer...

Answer 7

While we may have an option for you, we do not have the exact specs on your Allis grease seal part number 5013 29772. However, with the 1.6" ID and 2.5" OD measurements you provides, that is very close to our #58846. This particular grease…

view full answer...

Answer 8

By "mobile home type bolt pattern" I believe you are talking about a 5 spoke utility bolt pattern such as what is on the Dexter Trailer Hub and Drum Assembly - 6,000-lb and 7,000-lb Axles #8-174-5UC3. To measure your axle from hub face to…

view full answer...

Answer 9

The 7290 that you see is a casting number. It is found on AL-KO hubs that fit #99 spindles. I found that the bearings used are #28580 which would be the inner bearing and #25580 which would be the outer bearing. For the seal use #91030.

view full answer...

Answer 10

Normal operating temperatures for drum brakes range from 150-400 degrees F. During certain stopping conditions the brake heat can exceed 600 degrees. The effectiveness and stopping power of the brakes is significantly reduced at these higher…

view full answer...

Answer 11

I really wish we had replacement parts still for the Atwood couplers but since they've been out of business for so long we don't have any way to get the parts you are wanting.

view full answer...

Can a Winch be Mounted to Bulldog Winch Grille Guard # BDW733644B

Products Referenced in This Question

Continue Researching