Length of Rod in Polar T-Handle Latch # PLR5710

Question

Question:

how long are the rods on this latch?

asked by: Brett

1

Helpful Expert Reply:

I went out to our warehouse to take a look at the Polar T-Handle Latch # PLR5710 that you referenced in your question. I measured a length on the included rods of right at 48 inches or 4 feet from end to end.

expert reply by: Chris R

1

click to enlarge

Answer 1

The the MaxxAir shroud part #MA00-325001 is a fit for the Coleman Mach, Mach 1, Mach 3 and Mach 15 models and mounts like the original and includes mounting hardware and instructions. Mach is an entire model line of Coleman air conditioners and Mach…

view full answer...

Answer 2

After looking into this, everything I can find says that this unit falls under the Mach 3 category. The MaxxAir TuffMaxx Replacement RV Air Conditioner Cover for Coleman-Mach RV Air Conditioners #MA00-325001 is designed to fit Mach-1, Mach-3 and…

view full answer...

Answer 3

It sounds like something might've gone wrong during the installation of the MaxxAir TuffMaxx Replacement RV Air Conditioner Cover for Coleman-Mach RV Air Conditioners #MA00-325001. You'll want to go through these steps again to ensure that…

view full answer...

Answer 4

The part number you mentioned refers to an older Coleman-Mach AC but I wasn't able to track down any specific dimensions or what generation it belonged to within this line. The best option we have available is the MaxxAir TuffMaxx Replacement…

view full answer...

Answer 5

The correct replacement shroud cover for your Coleman AC unit Model 6759A707, is the MaxxAir TuffMaxx Replacement Shroud for Coleman-Mach RV Air Conditioners #MA00-325001. This comes in white, and is the only color option available. Part #PXXMCOVERB…

view full answer...

Answer 6

I've never heard of an actual third brake light connector on a camper shell to plug in on a truck and we don't carry any parts to do that. The light generally needs to be hardwired into the truck's brake light circuit. The issue with this…

view full answer...

Answer 7

To see all of the correct wheel and tire combos you'd need check out the link I attached. The option I would recommend is the part #TA43RR which is a Load Range C tire size ST175/80R13 mounted on a white spoke wheel with a bolt pattern of 5 on…

view full answer...

Answer 8

If you are needing the hub and drum assembly then you will want to go with the Dexter Trailer Hub and Drum Assembly #8-201-5UC3-EZ but if you are just looking for an idler hub then you will want part #8-213-5UC1 instead. These come with the correct…

view full answer...

Answer 9

Since you have a wheelbase/axle spacing of 38 inches the correct hanger kit for slipper springs would be the part #HAP-105-205-01. And then for a 7k trailer axle the u-bolt kit you'd want would be the part #APUBR-8. I attached the diagram to use…

view full answer...

Answer 10

The 40 amp fuse for your 2006 Chevrolet Silverado tow package is used for the 12 volt battery charge circuit. This fuse is located toward the front of the underhood fuse box closest to the front auxiliary positive post (see photo). There may be a…

view full answer...

Answer 11

On a 2005 Chevy Silverado 1500, If you are facing the front of the truck looking at the power distribution box, there will be a post at the back left side and a fuse slot near it. It is that fuse slot that you will install a 30 amp fuse. I have…

view full answer...

Answer 12

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Length of Rod in Polar T-Handle Latch # PLR5710

Product Page this Question was Asked From

Continue Researching