Mounting Hole Spacing on Demco A-Frame Trailer Coupler DM14793-81
Question:
HI I am looking at Demco A-Frame Trailer Coupler w/ Jack Hole - eZ-Latch - Black - 2inch Ball - Bolt On - 10K Do you have a dimension for the bolt holes distance from the top of the A-frame down to the bolt holes themselves? I am trying to figure where the holes will go on my Frame rail. Thanks.
asked by: Brett D
Helpful Expert Reply:
I went to our warehouse and measured the Demco A-Frame Trailer Coupler # DM14793-81 to get you the dimensions you need.
From the UNDERSIDE of the top plate, the part of the coupler that will actually contact the top of the A-frame, the hole centers are down 1-1/2-inches. If measured from the TOPSIDE of the coupler top plate the distance down to the hole centers is then 1-3/4-inches.
The side to side hole spacing is 3-inches on-center on each side of the coupler.
Each of these dimensions is shown in the linked photo that I prepared for you.
Product Page this Question was Asked From
Demco A-Frame Trailer Coupler w/ Jack Hole - eZ-Latch - Black - 2" Ball - Bolt On - 10K
- A-Frame Trailer Coupler
- Standard Coupler
- Bolt-On
- 10000 lbs GTW
- 2 Inch Ball Coupler
- Auto Latch
- Demco
more information >
Continue Researching
- Search Results: a frame
- Search Results: coupler
- Article: Most Popular Wheel Bearings
- Shop: Demco A-Frame Trailer Coupler w/ Jack Hole - eZ-Latch - Black - 2" Ball - Bolt On - 10K
- Q&A: Difference Between 10K Demco eZ-Latch Couplers
- Shop: Bulldog Heavy-Duty Cast Head Coupler w/ Wedge Latch - 2-5/16" Ball - A-Frame - 15,000 lbs
- Shop: Demco Cast Head Coupler w/ Jack Hole - eZ-Latch - 2" Ball - A-Frame - Bolt-On - 10K
- Shop: Demco A-Frame Trailer Coupler w/ Jack Hole - eZ-Latch - Zinc - 2" Ball - Bolt On - 10K
- Shop: Replacement Trailer Hub Bearing - 25580
- Q&A: Recommended High-Capacity Silver-Painted or Zinc Plated A-Frame Trailer Coupler
- Q&A: Adapter to Use a Tow Bar with a 2 inch Shank in a 3 inch Hitch Receiver Opening
- Q&A: A-Frame Coupler For 2015 H&H Enclosed Trailer
- Q&A: Bulldog Heavy Duty Coupler to Replace Fulton Heavy Duty Coupler
- Q&A: Can Weld-On A-Frame Trailer Coupler be Replaced with a Bolt-On Coupler
- Q&A: What Hardware is Needed for the Bulldog Heavy-Duty Cast Head Coupler With Wedge Latch
- Shop: Demco 50-Degree A-Frame Trailer Coupler w/ Jack Hole - eZ-Latch - Zinc - 2-5/16" Ball - 21K
- Shop: Replacement Trailer Hub Bearing - 15123
- Video: Bulldog A-Frame Trailer Coupler - Standard Coupler - BD44150WH301 Review
- Video: Bulldog Heavy-Duty Cast Head Coupler Review
- Shop: Trailer Hitch
- Search Results: offset rims
- Search Results: wheel offset
- Article: Trailer Tire Sizing
- Video: Demco eZ-Latch A-Frame Trailer Coupler Installation - 2020 Taxa Mantis Travel Trailer
- Shop: Trailer Wiring