Is There Drilling Required to Install a CURT Trailer Hitch # C11244 on a 2001 Mitsubishi Diamente
Question:
On this product, it states no welding. Is drilling required? If so how much? And where. My car is a Mitsubishi- diamante- 2001 Sedan
asked by: Butch
Expert Reply:
Yes, there will be drilling to install this CURT Trailer Hitch Receiver with Drawbar # C11244. You will need to drill three holes into the rear panel of your 2001 Mitsubishi Diamente. I attached installation instructions for you to check out that detail this process.
If you plan on doing some towing you may be interested in the following products to complete your setup:
Upgraded Circuit Protected Taillight Converter # 119178KIT (installation video attached)
Hitch Ball 1-7/8 inch # A-82
Hitch Ball 2 inch # A-80
Products Referenced in This Question
Tekonsha Tail Light Converter with 4-Way Flat Trailer Connector and Install Kit
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- Converter
- 1-1/2 Feet Long
- Universal Fit
- 4 Flat
- Tekonsha
more information >
1-7/8" Hitch Ball - 3/4" Diameter x 2-1/8" Long Shank - Stainless Steel - 2,000 lbs
- Trailer Hitch Ball
- Trailer Hitch Ball
- Standard Ball
- Stainless Steel
- 1-7/8 Inch Diameter Ball
- 2-1/8 Inch Shank Length
- 3/4 Inch Diameter Shank
- 2000 lbs GTW
- Class I
- Class II
- CURT
more information >
2" Hitch Ball - 3/4" Diameter x 2-1/8" Long Shank - Stainless Steel - 3,500 lbs
- Trailer Hitch Ball
- Trailer Hitch Ball
- Standard Ball
- Stainless Steel
- 2 Inch Diameter Ball
- 2-1/8 Inch Shank Length
- 3/4 Inch Diameter Shank
- 3500 lbs GTW
- Class I
- Class II
- CURT
more information >
