Is Carr Step CARR103991 One Step or Two Steps

Question

Question:

Is this one step or two. I thought I saw the same kit number with two steps?

asked by: Ken

0

Expert Reply:

Carr Step part # CARR103991-1 is a single black aluminum step, but you are correct that this same product is also offered as a set of two steps as part # CARR103991. If you purchase the 2-step kit the cost per step drops so there is a price benefit to ordering part # CARR103991.

You can see an installation video by clicking on the link provided. This video shows installation on a 2001 Dodge Ram.

expert reply by: Adam R

0

Answer 1

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

Hey Mark, so the correct Blue Ox base plate kit to use with the Blue Ox Ascent tow bar part #BX4375. is the part #BLU53FR. For lighting you can use #C96JR, and not have to worry about cutting into the taillight housing as this plugs inline with the…

view full answer...

Answer 4

The Erickson Retractable Tow Strap #EM77JR has a safe working load rating of 4,500lbs. This is the maximum weight for the vehicle or equipment you are towing. The 9,000lb rating is the break strength. This is the weight capacity the strap will break…

view full answer...

Answer 5

Dexter 8-249 hubs normally have inner bearings like Item #L68149 and outer bearings like Item #L44649. If these are your bearings (the size will be stamped on them) then it sounds like you need Trailer Hub and Drum Assembly Item #84556UC3 by Dexter…

view full answer...

Answer 6

For a keyless door latch we have the Global Link Ultra E Pro Electronic Lock for Travel Trailer w Keyed Alike Option #295-000183 which installs on the left side of the door (when looking at it from the outside) but the cutout requirement is much…

view full answer...

Answer 7

If you were to install the CARR steps #CARR103991-1 on your 2010 GMC Sierra they would stick out 8-5/8 inches from where they are installed.

view full answer...

Answer 8

Basically you need to remove a panel on the dash of your 2018 Lincoln Navigator and the connector is there for you to attach to. See attached picture.

view full answer...

Answer 9

There should be enough free play in the shackles to allow them to move. There is no specific torque rating for shackle bolts. The first thing you should make sure of is that the bolts you use are long enough so that when installed you will have at…

view full answer...

Answer 10

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...