Mounting Hole Dimensions of Round A-Frame Trailer Jack
Question:
I was wondering what the hole pattern dims. are for the TJA-2001-B jack are. I am having a plate laser cut for mounting this jack and need the hole info. A cad drawing would be great if at all possible.
asked by: Jeff S
1
Helpful Expert Reply:
The Round A-Frame Trailer Jack # TJA-2001-B has standard mounting hole dimensions which are 3 inches apart center on center. I went to the warehouse to measure and found the same dimensions. I also used a digital caliper to measure the holes themselves and found that they measured 0.42 inches horizontally and 0.75 inches vertically.
expert reply by:
Kyle S
1
click to enlarge
Product Page this Question was Asked From
Round A-Frame Trailer Jack - Topwind - 14-1/4" Lift - 2,000 lbs
- Trailer Jack
- Car Hauler
- Enclosed Trailer
- Utility Trailer
- A-Frame Jack
- Leveling Jacks
- Tongue Jacks
- Steel
- 1001 - 2000 lbs
- Topwind Jack
- 14 Inch Lift
- Bolt-On
- Weld-On
- No Wheel or Foot
- etrailer
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Compatibility of LED Hitch Cover FHG72VR with Wiring Harness 118384 on 2012 Chevy Colorado
- Q&A: Manual A-Frame Trailer Jack with Shortest Retracted Bracket Height
- Article: Trailer Wiring Diagrams
- Q&A: 2 inch Outer Diameter A-Frame Trailer Jack Recommendation
- Q&A: Replacement Tray for Stromberg Carlson Trailer Tray Dimensions
- Q&A: Recommendation for an A-Frame Jack with a Lower Retracted Height Than 8 Inches
- Q&A: Replacement Options For An American Enterprise CS-2000XL Power Converter
- Q&A: What Wiring Would be Needed to Install a Third Brake Light Mounted to a Boat Outboard Motor
- Article: Trailer Tire Sizing
- Article: Trailer Hitch Receiver Sizes
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: Trailer Jacks
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)