Kats Block Heater Cartridge Location for 2003 Ford Expedition with 5.4 liter V8

Question

Question:

Do you have a picture of where the block heater gets installed on the 2003 Expedition 5.4 engine.

asked by: Bob F

0

Expert Reply:

I checked with Kat's and for the 5.4 liter V8 you have installed in your 2003 Ford Expedition the correct cartridge location you'd need to use is on the driver side of the block at the back closest to the windshield.

expert reply by: Jameson C

0

Answer 1

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...

Answer 2

No, there are no custom fit base plates for a truck that old. The only thing I can offer you is the Blue Ox Heavy-Duty Universal Bolt-On Adapter Tabs item #BX88266. These are compatible with Blue Ox tow bars and are a universal part. They bolt…

view full answer...

Answer 3

I did add a diagram that should be helpful although as of right now we have not yet had a chance to made a video showing the Kat's Custom Engine Block Heater #KH11409 being installed on a 2015 Mazda CX-5. After checking out the instructions for…

view full answer...

Answer 4

Yes, we have the Kat's block heater part #KH11409 that is a confirmed fit for your 2023 Mazda CX-9. This fits in place of a frost plug which is located around the back side of the block as your facing front of car on the driver side.

view full answer...

Answer 5

Kat's does recommend coating the cartridge with NSCG silicone grease G-624 before inserting the cartridge heaters like the #KH11813 into the block.

view full answer...

Answer 6

I confirmed with Kat's Heaters that the port location for the Custom Fit Engine Block Heater #KH11815 on your 2018 Ford F-150 with the 3.5L V6 EcoBoost engine is on the right front of the block. I went ahead and attached a diagram that shows this…

view full answer...

Answer 7

Yes they do. They are not super detailed but the Kat's heaters do come with install instructions. It does not come with specific installation instructions for your vehicle, but it does come with a set of universal instructions that would still…

view full answer...

Answer 8

Thanks for the pictures! A weight distribution hitch is recommended based off of the tongue weight of your trailer and is typically between 10% and 15% of your trailer's total weight. 580 lbs seems extremely low for a 7,600 lbs trailer. Usually…

view full answer...

Answer 9

Where to start with your wiring harness depends on what available connectors you have under the bumper of your 2020 Ford F-150 and also what trailer connector you're looking to add on your truck. If your truck already has the square shaped…

view full answer...