Installation of a Tekonsha PRIMUS IQ Electronic Brake Controller # TK90160 in a 2007 Jeep Liberty

Question:

Have a 2007 Jeep Liberty-need inf.on how to wire a brake controler TK90160, also were do you tie into tail lights to set up trailer elect plug? I can use all the help I can get. Thanks

asked by: Gary

Expert Reply:

If you do not have any trailer connectors at the rear of your vehicle you would first need a Hopkins Custom Fit Vehicle Wiring # 42475 to give you a 4-way connector at the rear of your vehicle. The plug you are looking for is located behind the paneling in the back of the vehicle on the passenger side. I attached installation instructions for you to check out.

Next, you will need a Brake Controller 7 & 4 Way Installation Kit # ETBC7 so you can convert the 4-way to a 7-way connector. I attached installation instructions for this product also.

Now you will be ready to install the Tekonsha PRIMUS IQ Electronic Brake Controller # TK90160. I attached installation instructions for this product also.

expert reply by: Jameson C