Recommended 12 Inch Rotor for Idler Hubs with 6 Lugs

Question

Question:

I AM LOOKING FOR 12inch VENTED SLIP ON DACROMET ROTORS TO REPLACE THE RUSTED ONES FROM MY KODIAK-225 BREAKS ON MY TRAILER . THERE ARE 6 LUG NUTS

asked by: PAUL M

0

Expert Reply:

I have a couple rotor kit options for you. We have the Kodiak Disc Brake Kit - 12" Rotor - 6 on 5-1/2 - Dacromet and Stainless Steel - 6,000 lbs # K2R526DS or the Kodiak Disc Brake Kit - 12" Rotor - 6 on 5-1/2 - Dacromet and KodaGuard - 5,200 to 6,000 lbs # K2R526DKG.

If you just want the rotor, I recommend the Kodiak 12" Rotor - 6 on 5-1/2 - Dacromet - 5,200 lbs to 6,000 lbs # KR12D. This rotor has bolt holes for 1/2 inch studs.

expert reply by: Jason S

0

Answer 1

I've actually answered a similar question on this before and found: In my research I found that the grease seal you are looking for could have an inner diameter of either 2.24 or 2.12 inches and an outer diameter of 3.37 inches when measured with…

view full answer...

Answer 2

To replace the rotors of your disc brakes, the Kodiak #KR12D will work just fine as they are a standard 12-1/6" wide overall and have an inner diameter of 7-2/3" (where the hub sits). We don't have a dimensional drawing but as long as…

view full answer...

Answer 3

The Rota-Flex pin boxes will work just fine with the B&W Companion OEM 5th Wheel Hitch for Chevy/GMC Towing Prep Package #BWRVK3710 that you're referencing. To our knowledge the only standard 5th wheel hitches that the Rota-Flex isn't…

view full answer...

Answer 4

The "Trailer Disconnected" error message on the dash with a factory brake controller is usually related to an issue with the blue brake output wire that runs from the brake controller to the 7-Way connector. The fact that the issue remains…

view full answer...

Answer 5

From what we've found online, the proper replacement for your S2T216AP2 is #STL16RB for the passenger side and #STL17RB for the driver side.

view full answer...

Answer 6

The DeeMaxx Disc Brake Kit #DE82FR with the Maxx coating has a salt spray rating of over 1,000 hours while the DeeMaxx Disc Brake Kit #DE54VR with the Stainless construction isn't rated for salt spray, but when I spoke with the owner he said the…

view full answer...

Answer 7

Without any background information, it will be hard to say what you have going on. Have you recently replaced the coupler or master cylinder? Did the brakes previously function correctly, but are recently locking up when the vehicle is placed in…

view full answer...

Answer 8

As long as your new axle has a 5-bolt brake mounting flange, the Kodiak #K2R526DS should work fine for you. You'll also need a brake line kit like part #DM5424 and an actuating coupler like part #099-175-20 for a 2 inch trailer ball. I've…

view full answer...

Answer 9

In regards to disc trailer brakes, we don't recommend mixing brands like using Kodiak rotors with Dexter/UFP calipers etc. The UFP stuff is mostly discontinued so best option would be to upgrade to the Kodiak Disc Brake Kit part #K2HR526DKG which…

view full answer...

Answer 10

I have attached a link to our product page for the disc brake kits we offer for 5,200 lb axles. One of the kits I recommend is the Kodiak Disc Brake Kit, part #K2HR526DKG. This kit includes 2 KodaGuard-plated calipers, 2 Dacromet-plated hub-rotor…

view full answer...

Recommended 12 Inch Rotor for Idler Hubs with 6 Lugs

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching