Parts Needed to Install Brake Controller in 1997 Tacoma
Question:
Hello, my tacoma has a 4 pin trailer harness aftermarket the convertor was at the 4 pin plug itself and has been damaged. I cut the connector off and can splice a convertor in. Which one should I get? The end goal is to connect my truck to a combo 4 pin/7 pin connector at my bumper. My tacoma had a 3 wire system and my camper is two wire. Thanks you! Also, I have a 2010 Mazda CX 9 and bought a Tekonsha brake controller. Do you have a factory plug to go from the controller to the mazdas wiring. I dont think the mazda came with a factory installed trailer wiring harness. Even so, I would think there would be some kind of connector to connect the controller to the Mazda brake switch. Thanks!!!
asked by: John L
Expert Reply:
You will need to start with a 4-way since yours is gone now. For that you would want the # 118379.
From there you would need to convert the 4-way to a 7-way so that you can install the brake controller. For that you will want the Brake Controller Install Kit and 7-Way Adapter part # ETBC7. I attached installation instructions and an install video for this product as well.
For a brake controller I would recommend the Prodigy P2 Brake Controller part # 90885. This is our best selling brake controller because of how well it works and how easy it is to setup.
Products Referenced in This Question
Tekonsha Prodigy P2 Trailer Brake Controller - 1 to 4 Axles - Proportional
- Trailer Brake Controller
- Proportional Controller
- Electric
- Electric over Hydraulic
- Automatic Leveling
- Under-Dash Box
- Dash Mount
- Up to 4 Axles
- LED Display
- Up to 360 Degrees
- Tekonsha
more information >
Universal Installation Kit for Trailer Brake Controller - 7-Way RV and 4-Way Flat - 10 Gauge Wires
- Accessories and Parts
- Trailer Brake Controller
- Installation Kits
- etrailer
more information >
Product Page this Question was Asked From
T-One Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- Converter
- Custom Fit
- 4 Flat
- Tekonsha
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Comparing Equa-Flex and Road Armor Equalizers For 2000 Forest River WIldwood W/ 5200lb Axles
- Q&A: Equalizer Replacement Options for Dexter 13-122 Equalizer
- Q&A: Recommended 16' Mesh Tarp for Dump Trailer
- Q&A: Replacement Electric Brakes for Dexter PR-FF SEC-FF 5.2KPR-GGSEC-GG 12X2XQ 36-89
- Q&A: Can 12 Volt Battery Replace Two 6 Volt Batteries
- Q&A: Is a Master Key Needed to Install or Remove a Thule Lock Cylinder
- Article: How to Rent an RV
- Q&A: Using XTRM Universal Sealant to Replace Existing Original XTRM Caulk on Roof
- Article: What Exactly is Tongue Weight?
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Trailer Wiring Diagrams
- Article: Brake Controller Installation: Starting from Scratch
- Article: How to Choose the Right Trailer Hitch Class
- Article: How to Install a Brake Controller on Chevrolet / GMC 1999-2006 Pickups