Ball Mount Recommendation with More Rise than Curt # C45016
Question:
Can you recommend a draw bar with higher lift than a Curt draw bar #45016? I am using a wheelchair carrier and my current setup still scrapes on the ground when going up and down moderate driveways. Thanks.
asked by: Tim B
0
Expert Reply:
The Curt ball mount part # C45016 has a rise of 2-5/8 inches so for a ball mount with more rise you'd want the # C45522 if you were looking for 3-7/8 inches of rise instead. This also fit a Class II hitch.
You would want to check out the FAQ article I attached below on picking out the correct rise/drop ball mount as well.
expert reply by:
Jameson C
0
Products Referenced in This Question
Curt Class II Drawbar - 3-1/8" Rise - 11-1/4" Long - 3,500 lbs
- Trailer Hitch Ball Mount
- Fixed Ball Mount
- No Ball
- 3/4 Inch Ball Hole Diameter
- Steel Shank - Gloss Black
- Rise - 4 Inch
- Fits 1-1/4 Inch Hitch
- 3500 lbs GTW
- Class II
- CURT
more information >
Product Page this Question was Asked From
Curt Class II Drawbar - 2-5/8" Rise, 3-1/4" Drop - 9-3/8" Long - 3,500 lbs
- Trailer Hitch Ball Mount
- Fixed Ball Mount
- No Ball
- 3/4 Inch Ball Hole Diameter
- Steel Shank - Gloss Black
- Drop - 3 Inch
- Rise - 2 Inch
- Fits 1-1/4 Inch Hitch
- 3500 lbs GTW
- Class II
- CURT
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Article: How to Choose the Right Trailer Hitch Class
- Q&A: Ball Mount for 2016 Ford Fusion
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Article: Steel vs. Aluminum Ball Mounts
- Article: Ball Mount Basics: Weight Capacity, Class, and Size
- Article: How to Measure for Trailer Hitch Drop
- Article: Trailer Wiring Diagrams
- Q&A: What is the Height With and Without Rise on Ball Mount for 2016 Ford Fusion
- Q&A: Bearings and Seal Needed for Lippert 8K Axle
- Article: My Trailer Hitch Doesn't Fit
- Q&A: Differences Between Curt, Draw-Tite, and etrailer.com Trailer Hitches for 2019 Subaru Outback Wagon
- Q&A: Replacement 1-7/8" Trailer Ball Coupler For a 2004 Shelby 5128 Coupler
- Q&A: Is there an Adapter to Fit a Hitch Ball with 1 Inch Diameter Shank in a 1-1/4 Ball Hole
- Article: How to Correct Noise from Exhaust Rattling Against a Trailer Hitch