Is it Possible to Install Draw Tite Hitch 41990 with Zero Drop Mounting Brackets
Question:
I have a 2018 nexus rv, e450 super duty cutaway van. It has a reese hitch on it that s three inches from the top of the frame to the top of the receiver. I am looking at 41990 which is straight and needs to be welded with the 7inch or 12inch brackets. I would like mine to not at,all so,i gain the 3inch I have now.we hit a lot when going on and out of places. Are there any 0inch brackets?bolt on preferred
asked by: Thomas M
Expert Reply:
With the part # 41990 we do not have any zero drop brackets to use when installing it. Due to the universal nature of this cross tube though you could pretty take it to a qualified fab shop and have them fabricate a way to mount it to your trailer in the location you want.
Product Page this Question was Asked From
Draw-Tite Ultra Frame Service Body Trailer Hitch Cross Tube - Class V - 2"
- Heavy Duty Receiver Hitch
- Weld-On
- 44 Inch Wide
- 1600 lbs TW
- 16000 lbs GTW
- Class V
- 2 Inch Hitch
- No Drop
- Draw-Tite
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Hitch Recommendation for a Ford E-450 Bus
- Q&A: Are All RV Hitches for a 2004 Fleetwood Tioga Rated for 3,500 lbs?
- Q&A: Parts Needed to Tow Trailer With Brakes Using 1992 Dodge D250
- Q&A: Trailer Hitch, Wiring, and Brake Controller for 2010 Mitsubishi Fuso FE145
- Q&A: Recommended Class V Hitch For A 2020 Ford F53 Chassis
- Article: How to Choose the Right Trailer Hitch Class
- Q&A: Deflection for 2K Timbren Axle-Less Trailer Suspension with 4" Lift
- Q&A: Receiver Mount for Trailer Needed To Operate a 12,000LB Winch
- Article: My Trailer Hitch Doesn't Fit
- Article: Stability Control for Heavy Duty Vehicles
- Article: Best Air Bag Suspension (2023)
- Article: Performance Chips and Modules
- Article: Rooftop Cargo Carriers
- Article: Testing Trailer Brake Magnets for Proper Function