Does Kodiak XL ProLube Oil Bath Hub Body and Cap # XLPROLUBE1980 Come with Seals

Question

Question:

Im looking for a replacement cap for my 2004 Mastercraft trailer. I see there was another person looking for the same here. My question is it mentions in the product description that there are seals needed. I only need the cap as the seal on the other side of the hub is o.k. Which seals would I need for just the cap? I can be reached at 209 986-3954 if necessary. Thanks!

asked by: Don C

1

Helpful Expert Reply:

The # XLPROLUBE1980 comes with the seal for between the screw on portion of the # XLPROLUBE1980 and the metal housing. The actual hub seal is not included so this would be what you would want.

expert reply by: Jameson C

1

Answer 1

Basically you just want to fill the oil, like part #XLPROLUBE, up to where that center plug will fit on the Oil Cap Kit #RG04-300. When using grease to lubricate a hub you want to fill it up completely but with an oil lubrication kit the oil is…

view full answer...

Answer 2

Since the Kodiak grease/oil cap #KPCAP is made of tough UV-resistant polycarbonate you don't need to worry about the torque recommendation on the item. Polycarbonate is a very tough material and you can rest assured that Kodiak would not…

view full answer...

Answer 3

Yes, the Kodiak Disc Brake Caliper #KDBC250D will fit the caliper bracket that comes in the HydraStar Disc Brake Kits, like Kit #HSE7K-T1. We also have the Stainless Steel Kodiak Disc Brake Caliper #KDBC250S and Stainless Steel Ceramic Brake Pads…

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 6

In order to verify the spindle dimensions so that you can pick out the correct hub/drum you have to get exact dimensions. For that you need to use a digital caliper like part #PTW80157. For how old your trailer is this is especially important as the…

view full answer...

Answer 7

A BT8 spindle would have a diameter of .99 of an inch where the bearings would both install and would have a diameter of 1.24 where the great seal would ride. That would require a hub part #AKIHUB-440-2-1K for an idler hub. A BTR spindle would have…

view full answer...

Answer 8

You can convert surge brakes to an electric over hydraulic braking system. To do this, you will need an electric over hydraulic actuator and a brake controller. For an electric over hydraulic actuator, I recommend looking at the Carlisle HydraStar…

view full answer...

Answer 9

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 10

First you will need to remove the old hydraulic equipment. Remove the surge coupler or actuator, remove all the lines, and finally remove the brake assemblies. If you have 10 inch diameter hub and drums, you may need to replace those as well. If you…

view full answer...

Answer 11

To find the load capacity for your axle you should look on the trailer VIN plate or sticker that lists the VIN number. The weight rating of the axle should be listed on that same plate or sticker. Also, the axle could have a tag or plate on it that…

view full answer...

Answer 12

The Dexter Nev-R-Adjust electric trailer brakes can be manually adjusted. There are a couple teeth of the adjustment wheel that are exposed just under the lever that you referenced. I have attached a photo showing the teeth. You will likely need a…

view full answer...

Does Kodiak XL ProLube Oil Bath Hub Body and Cap # XLPROLUBE1980 Come with Seals

Product Page this Question was Asked From

Continue Researching