Could RV Screen # 052963799941 be Used on Opening that Measures 90 inch Tall x 69 1/2 inch Wide

Question

Question:

The back of my trailer measures 90inch tall x 69 1/2inch wide. Do you have a screen that would fit? The one I seen measures 90 1/2inch tall x 98 1/2inch wide. It seems too wide for my opening.

asked by: Lloyd

1

Helpful Expert Reply:

The RV screen part # 052963799941 is width and height adjustable up to 90-1/2" tall x 98-1/2" wide. It could easily be adjusted narrower to fit your 69-1/2 inch wide opening.

expert reply by: Jameson C

1

Answer 1

Yes, the LaSalle Bristol CrossBreeze Screen, #3441409775PBK is attached to the inside wall of your toy hauler. The inside-wall-to-inside-wall measurement is what is crucial for fitment. For your RV, you provided a measurement of 98-1/2" so the…

view full answer...

Answer 2

Your ST235/80R16 spare tire when fully inflated does indeed have an overall diameter of about 31-inches so your measurement is right on. For reference the linked article includes a chart that shows the overall diameters of various trailer tire sizes.…

view full answer...

Answer 3

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 4

I've never heard of an actual third brake light connector on a camper shell to plug in on a truck and we don't carry any parts to do that. The light generally needs to be hardwired into the truck's brake light circuit. The issue with this…

view full answer...

Answer 5

You will need the Red LED Trailer Clearance or Side Marker Light #328-K-52 or Amber LED Trailer Clearance or Side Marker Light #328-K-51 for your 2018 Forest River Sunseeker motorhome. These lenses have the same Top Command SAE-AP2-16 markings on the…

view full answer...

Answer 6

Since you have a wheelbase/axle spacing of 38 inches the correct hanger kit for slipper springs would be the part #HAP-105-205-01. And then for a 7k trailer axle the u-bolt kit you'd want would be the part #APUBR-8. I attached the diagram to use…

view full answer...

Answer 7

What you're going to need is two of the transfer switches in that case. I have attached a diagram from Furrion that shows you how you're going to need to hook the two transfer switches #F30ATS up: -one to the other, then one branching off to…

view full answer...

Answer 8

To see all of the correct wheel and tire combos you'd need check out the link I attached. The option I would recommend is the part #TA43RR which is a Load Range C tire size ST175/80R13 mounted on a white spoke wheel with a bolt pattern of 5 on…

view full answer...

Answer 9

On a 2005 Chevy Silverado 1500, If you are facing the front of the truck looking at the power distribution box, there will be a post at the back left side and a fuse slot near it. It is that fuse slot that you will install a 30 amp fuse. I have…

view full answer...

Answer 10

The 40 amp fuse for your 2006 Chevrolet Silverado tow package is used for the 12 volt battery charge circuit. This fuse is located toward the front of the underhood fuse box closest to the front auxiliary positive post (see photo). There may be a…

view full answer...

Answer 11

If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…

view full answer...

Answer 12

To tow your trailer that uses an RV style 7-way blade style connector with your semi that has a 7-pin connector, you need to construct an adapter that will also combine the brake signal into the right and left directional signal pins. This can be…

view full answer...

Could RV Screen # 052963799941 be Used on Opening that Measures 90 inch Tall x 69 1/2 inch Wide

Product Page this Question was Asked From

Continue Researching