Replacement Fuse Holder for Fan-Tastic Vent Roof Vent w/12V Fan - Powered Lift - FV807350

Question

Question:

3/8 of inch diameter 1 inch long just big enough to get fuse in it tabs broke off

asked by: Ron L

0

Expert Reply:

To make fuse access easier I recommend using an in line fuse holder, # C58470-1. This can hold a fuse rated for up to 10 amps. Vent # FV807350 uses a 4 amp slow blow fuse so this fuse holder is more than capable of handling the load.

expert reply by: Michael H

0

Answer 1

Normally the Tee goes between the tank and the regulator. You would use the hose you looked at, part #100476-120-MBS, and a Tee that has a quick disconnect fitting like part #103537-MBS. This would connect to an appliance that normally connects to a…

view full answer...

Answer 2

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

You are correct that this refrigerator does not have an ON/OFF switch or function. The best you can do is "Standby" that draws an unknown amount of power. One option is to pull the 12-Volt fuse at the RV power center. A much better option…

view full answer...

Answer 5

The Dometic RV Water Heater - Gas - Automatic Pilot - 12 Volt - 8,800 Btu - 6 Gal Tank Item AT96121 is the direct replacement for the GC6AA-10E. Unfortunately it is out of stock with no expected restock date. Instead I recommend the Furrion RV…

view full answer...

Answer 6

This has come up before and when speaking with my contact at Fan-Tastic Vent regarding your model 6600 vent with the 417RF remote. She did confirm that the current model remote #FV9068-81 will not work with your vent model. The original remote for…

view full answer...

Answer 7

The number ( 411 D) you provided doesn't correspond with a Fan-Tastic Vent roof vent model number, but if yours uses the remote control #FV9068-09 that you referenced, that tells us it's a 7350 Series Fan-Tastic Vent Roof Vent, like…

view full answer...

Answer 8

Hey Cliff, with the Replacement Controlled Motion Hinge #LC95VR to get the desired effect where the door doesn't swing open or closed all you have to do is replace is a single hinge and not all three.

view full answer...

Answer 9

If the lift motor will no longer operate with the controller but does when you apply direct 12 volt power then that tells me there is an issues with the control board. The only way to replace the control board on the Fan-Tastic Vent Roof Vent part…

view full answer...

Answer 10

The best way to confirm the weight capacity of your Dexter Torsion Axles is to find the lot number on the axle tag which is located on the center of the axle on the rear side. This tag should say Dexter Axle and then a 9 digit number. The number you…

view full answer...

Answer 11

Your Dometic 57915.531 is a 13.5k BTU AC unit which the Advent Air RV AC Unit #ACDOM135 is the same size and is also designed to replace Dometic units.

view full answer...

Answer 12

If you are just looking for a new converter, the Replacement Converter for Parallax/Magnetek or WFCO RV Power Centers part #PD4635V will be a direct upgrade for the Magnetek Converter Series 6300 Model 6332 that you have now.

view full answer...