Parts Needed to Install Brakemaster On RV When Tow Vehicle is Already Set Up

Question

Question:

We just sold our Rv and purchased another one, so the airbrake connection is no longer there. We have a 40foot Phaeton and 2008 Rubicon with a roadmaster tow. Someone told us we would compromise the airbrakes by feeding into them.. Should we chose another source for the braking system?

asked by: Debbie G

0

Expert Reply:

For the BrakeMaster parts for the RV side of your setup you will need a car to RV air line assembly, # RM-921004-88. I also recommend the quick disconnect kit, RV side, # RM-921004-60. And you will need some air line, # RM450700, sold by the foot.

Inside the RV you will need kit # RM-98850.

expert reply by: Jameson C

0

Answer 1

The vacuum assist brake system you have in your vehicle makes it so that you don't have to press too hard on the brake pedal to slow down. When the vacuum is not present (vehicle off) the brakes still work but you just have to press much…

view full answer...

Answer 2

One of the interesting aspects of the Roadmaster BrakeMaster #RM-9160 is that it is not adjustable in anyway. It syncs up so well with the air pressure of your tow vehicle that it does not need to be adjusted.

view full answer...

Answer 3

The most common locations for mounting the air reservoir portion of the Roadmaster BrakeMaster #RM-9160 are next to the driver's seat and under the dash near the left kick panel. If there is no room under the hood of your vehicle this would…

view full answer...

Answer 4

Roadmaster states that the air reservoir for the breakaway portion of the Brakemaster should be mounted in the towed vehicle, most often in the engine compartment, but it may be attached anywhere an air line can be routed from the top of the air…

view full answer...

Answer 5

I would be happy to help! What you will need to do to get the Roadmaster 2nd Motorhome Kit #RM-98850 installed in your 2022 Mercedes-Benz is first install the LED light in your Sprinter where ever you decide is the best location that is visible while…

view full answer...

Answer 6

Since your car already has the Roadmaster InvisiBrake Supplemental Braking System #RM-8700 installed, all you need is the 2nd motorhome kit, which is the following part number: - Roadmaster 2nd Motorhome Monitor/Alarm Kit #RM-98850

view full answer...

Answer 7

The installation instructions for Roadmaster second RV kit #RM-98850 are pretty straight forward. You would not tap into the blue wire because on a 7-Way blue is usually for electric brakes. If tapped into the blue wire the light would not work…

view full answer...

Answer 8

For the Invisibrake #RM-8700 we have a second motorhome kit with the part #RM-98850 which is the just monitor/alarm that installs in the motorhome like you need.

view full answer...

Answer 9

For just the components of the Roadmaster Invisibrake #RM-8700 that install on the motorhome what you'd need is the part #RM-98850.

view full answer...

Answer 10

The correct kit you would need to use the Invisibrake part #RM-8700 you have installed on your 2013 Jeep Wrangler would be the 2nd Motorhome Kit part #RM-98850.

view full answer...

Answer 11

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 12

When it comes to choosing between the Blue Ox Patriot #BLU37TR and the Brake Buddy Select 3 #HM39524, these systems are extremely similar in their setup and functionality. Both of these systems provide proportional braking in a compact and easy to…

view full answer...

Parts Needed to Install Brakemaster On RV When Tow Vehicle is Already Set Up

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching