Should 2002 Toyota Sequoia with Front End Lift be Level with AirRide Helper Springs Installed

Question

Question:

My sequoia has a 2inch front end lift on it, with the AirRide 1000 on the rear, when they are pumped up should it be level when I pull my car trailer ? Thanks

asked by: Timmy C

1

Helpful Expert Reply:

When adjusting the air pressure for the Air Lift AirLift 1000 Air Helper Springs # AL60812, you will want to set them so your vehicle is as level as possible when pulling your car trailer. Even with the front end lift, your 2002 Toyota Sequoia will ideally lose any of the rear sag you previously experienced with the trailer coupled.

The springs themselves can be adjusted between 5 psi to 35 psi, depending on your application.

expert reply by: Chris R

1

Answer 1

I took a look at the installation manual for both the Firestone Coil-Rite #F4124 and AirLift 1000 Air Helper Springs #AL60812 that fit your 2003 Toyota Sequoia and the directions do differ a bit in terms of cutting the factory bump stop. The…

view full answer...

Answer 2

The Air Lift 1000 Air Helper Springs #AL60812 are confirmed to fit your 2002 Toyota Sequoia. They'll do great helping you tow your trailer.

view full answer...

Answer 3

With the coil spring suspension enhancement kits like the part #AL60812 that fits the stock suspension of your 2007 Toyota Sequoia there isn't a spacer or way to make them taller if you were to add a lift that increased the travel of the…

view full answer...

Answer 4

The Hellwig Adjustable Big Wig Rear Anti-Sway Bar #HE94FR is only going to leave a few inches between it and the spare tire, as you can see in the attached picture. Depending on how far forward you have the tire it could potentially interfere with…

view full answer...

Answer 5

The best Air Lift air bags for your 2022 Chevy Silverado 1500 4x4 are the 5,000 lb option: - Air Lift LoadLifter 5000 Air Helper Springs #AL57288 The 5,000 lb capacity is the best for your truck because you won't need to come near that capacity,…

view full answer...

Answer 6

We have run into this quite a few times in the past, and the best option will be replacing the Lance 7-pin connector with a standard 7-way blade connector like the #PK12706. This will give you a standard 7-way connector to plug into the factory 7-way…

view full answer...

Answer 7

Here is the wiring diagram from SeeLevel for the Monitor #SE94VR. I hope this helps you clear things up and get it working.

view full answer...

Answer 8

Hi John, I'm sorry you weren't given a set of instructions to go along with your SeeLevel RV Holding Tank Monitor #SE94VR. I've attached a diagram below showing that the White wire will run to your water pump, Red to your 12v power…

view full answer...

Answer 9

In some applications an angled spacer #AL79GV will be needed as oppose to a straight spacer #AL52460, to keep the upper and lower mounting brackets as parallel as possible. To determine which spacers are right for you, you will have to measure on a…

view full answer...

Answer 10

Since you have a Dometic AC unit the best option to replace it from Advent would be the part #ACDOM135 which was designed for this exact situation and would allow you an easy install since the electronics would plug right in.

view full answer...

Answer 11

It will! I verified with Timbren for you that your 2023 Toyota Tundra TRD Pro is 100 percent compatible with the Timbren system, with the correct part being the following: - Timbren Suspension Enhancement System #T45MR This is a nice upgrade for a…

view full answer...

Answer 12

We do have everything you need to install a 7-Way on your 2020 Subaru Outback Wagon so you can utilize a brake controller but we need to start off by making sure you have a 4-Way for the basic trailer lighting functions. If you don't already have…

view full answer...

Should 2002 Toyota Sequoia with Front End Lift be Level with AirRide Helper Springs Installed

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching