Does a 1976 Starcraft Starflight Use 3/4 Inch or 1 Inch Wide Trim

Question

Question:

1976 starcraft starflight 6 What size vinyl trim to use. 1 inch or 3/4 ?

asked by: Nancy W

0

Expert Reply:

I couldn't say what size trim was used on your 1976 StarCraft Starflight so if there is any trim remaining on it I urge you to measure it to determine what would be the correct size to use. If that is not possible then I recommend to err on the side of caution and go with Camco RV Vinyl Trim Insert - White - 100' Long x 1" Wide # CAM25202 which you could trim down some if necessary.

expert reply by: Michael H

0

Answer 1

The Premium RV Vinyl Insert Trim Molding - 25' - White Item #37210025 is approximately 1/16" thick.

view full answer...

Answer 2

The Camco RV Vinyl Trim Insert - White - 100' Long x 1" Wide #CAM25202 is designed to fit all the standard trim rails. The rails normally have the lip on either side that the vinyl tucks under. I've attached a photo of this trim to…

view full answer...

Answer 3

It sounds like you may be looking for a vinyl trim insert like the Camco - Black #CAM25212. This vinyl trim insert is 100 feet long and 1 inch wide and can be used to replace cracked or stained trim on your RV's roof edge or trim molding. It is…

view full answer...

Answer 4

The overall width of Camco RV Vinyl Trim Insert #CAM25212 is 1 inch. We have various styles of trim in beige, black, brown, chrome, and white but no blue. I have included a link to what we do have for you to view.

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 7

For sag from towing a trailer the best recommendation I can make is actually a weight distribution system. Suspension enhancement will help level your truck while towing. But the advantage to a weight distribution system is that it levels the vehicle…

view full answer...

Answer 8

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 9

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 10

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 11

Trailer wheel bearings are specific to the spindle that is installed on the axle that is on your trailer. You will need to safely support the trailer, remove the wheel and tire, remove the grease cap, remove the cotter pin and washer that secures the…

view full answer...

Answer 12

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

view full answer...

Does a 1976 Starcraft Starflight Use 3/4 Inch or 1 Inch Wide Trim

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching