What is the Cable Size and Type for the Antenna Extension for Voyager Digital Wireless System

Question

Question:

Can you tell me if the wiring to the Voyager external mount antenna is RG6 and same as TV cable? If the wiring is too long to go from camera to side of trailer, I want to trim and put on my own water tight compression fitting.

asked by: Greg K

1

Helpful Expert Reply:

The cable that comes with Antenna Extension # WVOSAPANTEXT is a coaxial cable but it is much smaller than TV coaxial cable. From my research it is an RG-58/U based on the 50 ohm rating printed on the cable and the 0.8mm core diameter.

expert reply by: Michael H

1

Answer 1

My first thoughts on your Voyager WiSight Wireless System, #WVOS541, are, there is an issue getting a strong wireless signal. You've checked power to the monitor but what about the camera and antennae, please verify that too. If you are…

view full answer...

Answer 2

The Antenna Extension for Voyager Digital Wireless System - Compatible with WVCMS130AP and WVCMS10B #WVOSAPANTEXT would be a possible solution to your problem. Unfortunately, there is not a larger antenna available for this system. The…

view full answer...

Answer 3

It sounds like your Equalizer isn't applying enough spring bar pressure. You are going to need to go through and set up the system properly. You will most likely need to adjust the angle of the head back from the vehicle further so that the…

view full answer...

Answer 4

Antennas are for either monitors or cameras generally, so the only antenna I know of that would go between the camera and the monitor is an antenna extension, and there is one from Voyager: - Antenna Extension for Voyager Digital Wireless System…

view full answer...

Answer 5

If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…

view full answer...

Answer 6

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and…

view full answer...

Answer 7

You will need the Red LED Trailer Clearance or Side Marker Light #328-K-52 or Amber LED Trailer Clearance or Side Marker Light #328-K-51 for your 2018 Forest River Sunseeker motorhome. These lenses have the same Top Command SAE-AP2-16 markings on…

view full answer...

Answer 8

I've never heard of an actual third brake light connector on a camper shell to plug in on a truck and we don't carry any parts to do that. The light generally needs to be hardwired into the truck's brake light circuit. The…

view full answer...

Answer 9

The installation instructions for this product are recommended for individuals who have experience winding torsion springs. If you have not worked with a torsion spring system before, we recommend contacting a local garage door company to install…

view full answer...

Answer 10

I would be happy to help you set up your 2022 Toyota Highlander to haul your new travel trailer. The wiring harness you currently have controls your trailer's lighting functions only. You do not need to rewire your Toyota you just need…

view full answer...

Answer 11

What you're going to need is two of the transfer switches in that case. I have attached a diagram from Furrion that shows you how you're going to need to hook the two transfer switches #F30ATS up: -one to the other, then one branching…

view full answer...

Answer 12

If your vehicle has a factory brake controller plug, you can simply use the Tekonsha Plug-In Wiring Adapter for Electric Brake Controllers – Ford, Item #3034-P, which will connect to the vehicle plug and the brake controller. On the new E-450…

view full answer...

What is the Cable Size and Type for the Antenna Extension for Voyager Digital Wireless System

Product Page this Question was Asked From

Continue Researching