Troubleshooting Right Running Light Not Working Properly on Trailer
Question:
Right running light is inoperative, works on left, all turn lamps are correctly working. When I test the running circuit on vehicle it lights solid then it flashes after about ten seconds with trailer disconnected? All new grounds and new trailer harness. Thanks in advance!!! Im stumped. Fuses all good and no burned wires
asked by: Rick C
Expert Reply:
Whenever there are lighting issues it is always best to start off by checking your grounds and connections to make sure that are clean and free of debris.
If you are not getting a good signal on your vehicle side connector or if your trailer lights are malfunctioning then I can help you trouble shoot that. If your the running lights on your vehicle are acting up you will need to take it in to a shop to get it looked at as all the information I will be able to provide is that you will need to check your wires and connections.
To troubleshoot the tail lights on your trailer you will want to start off by testing the connector on your vehicle with a Circuit Tester # PTW2992 and testing the connector on your trailer with an alternative 12V power source (different vehicle or your vehicle's battery).
If the connector on your vehicle is getting the proper signal but your trailer lights are still not functioning properly when hooked up to a different 12V system then you will need to check the wiring on your trailer. If it is the other way around, your trailer is lighting up correctly but the connector on your vehicle isn't working properly, then you will want to check the wiring on your vehicle.
Even though it sounds like you have checked the wiring for burns there are a few other things you will want to look for on either your vehicle or your trailer. Look for any spots where the wire is exposed, or bent. You will want to replace that wire with 14 Gauge Wire # DW07550-1 and Butt Connectors # DW05744-5.
If all of the wiring looks good on both your vehicle and your trailer and you have tested it and it worked properly separately then you will want to take your setup to a shop or trailer dealer so they can physically inspect it.
I have attached a helpful article on wiring for you to check out as well.
Products Referenced in This Question
Deka Heat Shrink Butt Connector - 16-14 Gauge - Nylon Insulation - Blue - Qty 5
- Wiring
- Wire Connectors
- Butt Connectors
- 16-14 Gauge
- Deka
more information >
Product Page this Question was Asked From
Continue Researching
- Article: Trailer Wiring Diagrams
- Q&A: Is the Roadmaster Stop Light Switch Needed for the Demco SBS Stay-IN-Play DUO
- Q&A: Parts Needed to Flat Tow 2022 Ford Bronco Badlands
- Q&A: Can Blue Ox Patriot Braking System be Used with 2023 Ford Bronco
- Q&A: Recommended Flat Towing Set Up for a 2023 GMC Canyon Denali
- Article: Troubleshooting 4 and 5-Way Wiring Installations
- Q&A: Can The Demco Stay-In-Play Be Transferred From One Vehicle To Another?
- Q&A: Will Demco Stay-IN-Play DUO Not Work if Battery Dies
- Q&A: Can Reverse Lockout Solenoid Click and Still not Function
- Article: Wiring Trailer Lights with a 6-Way Plug (It's Easier Than You Think)
- Article: Troubleshooting Brake Controller Installations
- Article: Towing a Trailer? Let's Talk About Brake Controllers
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Wiring Trailer Lights with a 5-Way Plug (It's Easier Than You Think)