Availability of a 4-Flat and 5-Flat Wiring Harness to Power an Air Compressor on a Trailer
Question:
I have an Adventure motorcycle trailer model AST 1 SE it has a 12 volt air 20 Amp compressor to raise and lower the trailer and and maintain its height while in tow and has a 5 pin connector can I get a 5pin connector on part #118519 or do I need to use a 4 to 5 pin convertor also can I splice into the battery wire providing power to the Tekonsha 11859 or do I need another feed wire. This unit will be used on a 2013 Lincoln MKX all wheel drive
asked by: John A
Expert Reply:
With the set up on your 2013 Lincoln MKX, you best option will be to install the T-One Vehicle Wiring Harness, # 118519, and then use the Tow Ready 4 Pole to 5 Pole Wiring Adapter, # 20036.
This the adapter will connect your 4 pole vehicle plug and 5 pole plug on your trailer. The trailer lights will be connected to your vehicle. The extra wire then can be wired up to the battery to power your air compressor. Depending on the amp draw of your compressor, I also recommend you wire in a fuse holder, like # SWC9545, according to the proper amperage.
Products Referenced in This Question
Tow Ready 4 Pole to 5 Pole Trailer Wiring Adapter
- Trailer Wiring
- Wiring Adapters
- Single-Function Adapter
- 0 - 5 Feet Long
- 4 Flat
- Plug and Lead
- 5 Flat
- Tow Ready
more information >
Spectro 12-Gauge Mini Fuse Holder - Qty 1
- Accessories and Parts
- Trailer Wiring
- Wiring
- Fuse Holder
- Spectro
more information >
Product Page this Question was Asked From
T-One Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- No Converter
- Custom Fit
- 4 Flat
- Tekonsha
more information >
Featured Help Information
Instructions
Continue Researching
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: My Trailer Hitch Doesn't Fit
- Article: How to Measure for Trailer Hitch Drop
- Article: Hitch Adapters and Extenders
- Article: What Do I Need To Tow A Trailer?
- Q&A: Does Pro Series Cargo Carrier # 63153 Have Hollow Shank for Anti-Rattle Device
- Q&A: Length of Shank on etrailer Cargo Carrier for Spare Tire Clearance of Jeep Cherokee
- Q&A: Trailer Hitch and Cargo Carrier Compatibility with a 2011 Toyota Sienna
- Article: How to Correct Noise from Exhaust Rattling Against a Trailer Hitch
- Q&A: Is the 17/32 Drill Bit Absolutely Necessary for Installation of Draw-Tite Hitch # 75992?
- Q&A: Is There Drilling Required to Install Trailer Hitch on 2011 Ford Edge
- Q&A: How to Release the Brakes on a Trailer Once the Break Away Switch Is Activated
- Q&A: Parts Needed to Flat Tow a 2017 Lincoln MKX AWD