Weight Distribution System Recommendation, 2007 Keystone Springdale 189FL and 2006 Toyota Sequoia

Question

Question:

Whats the proper Weight Distribution System for 2006 Toyota Sequoia and 2007 Keystone Springdale 189 23ft Travel Trailer? Trunnion or round bar?

asked by: Chris S

0

Expert Reply:

According to the research I did, the 2007 Keystone Springdale 189FL had a dry weight of 4,185 pounds, a carrying capacity of 1,770 pounds, and a tongue weight of 455 pounds. If the trailer were loaded to capacity, it would weigh in at about 6,000 pounds. Since tongue weight should be between 10 and 15 percent of the gross trailer weight, that would put the tongue weight at a range of 600 to 900 pounds.

When choosing a weight distribution system, you will want one that has a tongue weight capacity range that encompasses the trailer tongue weight, loaded and ready to tow. Since Keystone lists the tongue weight as 455, I recommend a system with a range of 400 to 800 pounds like Strait-Line Weight Distribution System w Sway Control, # RP66087.

The round bars have more than enough capacity for your trailer (trunnion bars are usually better for more heavy duty applications and cost a bit more) and this system comes with the required adjustable shank and dual-cam sway control. Dual-cam sway control is a pro-active system that stops trailer sway before it starts. All you will need is a properly sized ball like # 19286 (2-5/16 inch diameter) or # A-90 (2 inch diameter). I have included a link to the installation details for this system and a link to our FAQ article on weight distribution and sway control.

expert reply by: Michael H

0

Answer 1

I would start by inspecting the connector on your trailer and the vehicle to make sure there is not corrosion in the connector which could be causing a bad or weak connection. If there is corrosion in the trailer side connector, you would need to…

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 4

Hey Travis, congrats on the new 2024 Jayco Flight 284BHS! Your travel trailer looks to have a GVWR of 7,950 lbs so I recommend going with the Equal-i-zer Weight Distribution w/ 4-Point Sway Control #EQ37121ET and pairing it with the Shank…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

For sag from towing a trailer the best recommendation I can make is actually a weight distribution system. Suspension enhancement will help level your truck while towing. But the advantage to a weight distribution system is that it levels the vehicle…

view full answer...

Answer 7

If you just need a 4-pin to 7-pin trailer wiring adapter, then you can use part #C57672. This will plug into the 4-pin trailer connector on your brother's vehicle and give him the 7-pin socket for the trailer. Keep in mind, this will only give…

view full answer...

Answer 8

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 9

The brake controller port on a 2021 Ford F-150 (if equipped) will be located behind the coin tray in the center console. This will be accessed by removing the panel under the steering wheel. I have attached a video which shows this below. For a brake…

view full answer...

Answer 10

You do have the option to utilize the air brakes on your 2023 Freightliner Cascadia to control electric trailer brakes using the Hayes Air Actuated Trailer Brake Controller, part #HA100400C. However, we mostly recommend just using an electric brake…

view full answer...

Answer 11

The Redarc Tow-Pro Liberty #RED24FR is the way to go over the Elite #RED44FR as you get the nicer functions of the Elite at a lower price. The Elite has the ability to be the more preferred proportional style of controller as well as a time-delayed…

view full answer...

Answer 12

If your vehicle has a factory brake controller plug, you can simply use the Tekonsha Plug-In Wiring Adapter for Electric Brake Controllers – Ford, Item #3034-P, which will connect to the vehicle plug and the brake controller. On the new E-450…

view full answer...