Recommended Trailer Hitch Adapter To Reduce Play And Rattle

Question

Question:

what is available clamp? to assist in a rattle from a B and W hitch on my truck - a lot of play in the receiver

asked by: Russell P

0

Expert Reply:

If you are talking about rattle when you are towing something with your trailer hitch receiver like a ball mount, bike or cargo carrier I recommend the Blue Ox Hitch Receiver Immobilizer II, part # BX88224.

This adapter uses U-bolts to add additional horizontal and vertical tension to items that are installed in the trailer hitch receiver.

expert reply by: Jeffrey L

0

Answer 1

Yes, you can use the Blue Ox hitch immobilizer #BX88224 when towing a trailer. We have had similar questions before on this product in regards to its use with weight distribution systems when towing a trailer and Blue Ox has informed us several times…

view full answer...

Answer 2

Yes, the Blue Ox Hitch Receiver Immobilizer II #BX88224 that you referenced can be used while towing a small trailer as long as the hitch on the vehicle has a 2 inch opening. We have confirmed with Blue Ox that you can use this product in towing…

view full answer...

Answer 3

We do have the Rhino-Rack Masterkey Lock Barrels #RRRK093-2 which will provide you with 2 new lock cores and keys for your Rhino-Rack Zenith MasterFit Rooftop Cargo Box #RRRMFZ66. As far as pricing goes on the different sets they can change based on…

view full answer...

Answer 4

What you're going to need is two of the transfer switches in that case. I have attached a diagram from Furrion that shows you how you're going to need to hook the two transfer switches #F30ATS up: -one to the other, then one branching off to…

view full answer...

Answer 5

Yes, the Furrion Automatic Transfer Switch #F30ATS has a wiring diagram on the inside of the cover. I've attached a picture of the diagram as well as a picture of the terminals with their functions.

view full answer...

Answer 6

Is the battery of the breakaway kit charged? Does your tow vehicle have a brake controller installed?

view full answer...

Answer 7

The first thing to do is disconnect the trailer from the Liberty. Then using a circuit tester, like part #PTW2993, test each pin of the 4-Way. Clip the alligator clip of the circuit tester to the exposed post, the ground wire. Check each pin with the…

view full answer...

Answer 8

If you have more of the weight in the trailer on the left side then that could explain the uneven wear. Axles have a bow or camber in the middle. When weight is in the trailer it straightens out the axle some and the tires should wear evenly. When…

view full answer...

Answer 9

The part number you gave is no longer a valid number for Bulldog jacks. It sounds like you are looking for the Bulldog Square Jack w/ Footplate - Drop Leg - Sidewind - 15" Lift - 5,000 lbs #BD190754. This has a 5,000 lb lift capacity and an…

view full answer...

Recommended Trailer Hitch Adapter To Reduce Play And Rattle

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching