Tonneau Cover Tarp Replacement Recommendation for Truxedo Tarp TX570601

Question

Question:

Hi I have a TruXedo Lo Pro The number on one of the rails is 5706 06 17 09 looking for a replacement top and the velco strips that fit on the box rails. My box is a 5.8 .GMC 1500 Thanks.

asked by: Bill

0

Expert Reply:

It sounds like the tonneau cover you have is the # TX570601 which means the replacement tarp is the part # TX1117930.

expert reply by: Jameson C

0

Answer 1

For your TruXedo Lo Pro Soft Roll-up Tonneau Cover #TX571801 on your 2017 GMC Sierra 1500, you are going to want the Replacement Cover for TruXedo Lo Pro Soft, Roll-up Tonneau Cover #TX5718-CVR for a replacement cover. Just enter your S/N or date…

view full answer...

Answer 2

There are two TruXedo Lo Pro Soft Roll-up Tonneau Covers available for the 2015 Chevrolet Silverado 1500 with a 5-1/2' bed. You will have to identify which one you have in order to choose the correct replacement tarp. The #TX571801 uses…

view full answer...

Answer 3

The replacement TruXedo Lo Pro Soft Roll-up Tonneau Cover for your 2017 Chevy Silverado 1500 with a 5-1/2 foot bed is the Replacement Cover for TruXedo Lo Pro Soft, Roll-up Tonneau Cover - Black item #TX5718-CVR.

view full answer...

Answer 4

Most likely you'll need the #TX1117651 replacement tarp assuming that your original cover was a Truxedo Edge, #TX881101. If you could find the part or serial number on the existing header or cover, I can verify for sure. The header should have a…

view full answer...

Answer 5

We definitely have the replacement cover you need! Based off your instruction photo, you have the TruXedo Lo Pro QT model. I confirmed that this model is the exact same as the TruXedo Lo Pro Soft Roll-up Tonneau Cover - Black #TX570601 that is…

view full answer...

Answer 6

Yes, I have listed for your below the roof rack systems from Rhino-Rack, Thule, and Yakima that will fit the RetraxPRO XR Hard Tonneau Covers like part #RTT-80243 for your 2019 Ram 1500. Rhino-Rack Vortex Crossbar System part #RRVA180B-RRRLT600…

view full answer...

Answer 7

Hey Dustin, thanks for reaching out! I will recommend SumoSprings over Timbrens all day everyday because they are much more forgiving when the vehicle is unloaded. We've actually joked around here about how the Timbren kits will either give you…

view full answer...

Answer 8

Because the Retrax PRO MX Tonneau Cover #RT80467 for the 2019 Chevy Silverado 2500 covers the bed rails, you would not be able to use a ladder rack like the Thule TracRac #TH27000XT since that rack requires the use of the bed rails. The only tonneau…

view full answer...

Answer 9

SumoSprings would definitely be the solution I would recommend for your squatting concern. The SumoSprings Solo Custom Helper Springs - Rear Axle item #SS45MR have a 2,800 lbs capacity which would eliminate that carolina lift look you get when your…

view full answer...

Answer 10

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 11

For sag from towing a trailer the best recommendation I can make is actually a weight distribution system. Suspension enhancement will help level your truck while towing. But the advantage to a weight distribution system is that it levels the vehicle…

view full answer...

Answer 12

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...