How Long are the Hoses in Wheel Masters 2-Hose Inflation Kit WM8007

Question

Question:

how long are the extenders

asked by: C P

1

Helpful Expert Reply:

I spoke with my contact at Wheel Masters about valve extensions # WM8007. They measure 7 inches from the end that attaches to the valve stem to the start of the threads on the other end. I made a picture showing this for you.

expert reply by: Michael H

1

click to enlarge

Answer 1

Yes, the Wheel Masters 2-Hose Inflation Kit #WM8009 is absolutely compatible with your tire pressure monitoring system (TPMS). This kit will work with inner tires on 16", 16-1/2" and 19-1/2" dual wheels, has a 1-year warranty and is…

view full answer...

Answer 2

Wheel Masters 4-Hose Inflation Kit #WM8208 and #WM8008 can be used with rubber valve stems. They are only increasing the length of the stems making them easier to access. They do not put any additional stress on the valve stems so they would work for…

view full answer...

Answer 3

Thanks for the pictures, I can see why you're concerned now. It looks like you have some 135 degree valve extenders that just aren't quite long enough to pass through the hand holes of the wheel cover. You could try using a longer 180 degree…

view full answer...

Answer 4

You were on the right track- the Wheel Masters 2 Hose Inflation Kit #WM8009 are designed for 16" to 19-1/2" wheels like the ones on your Winnebago Access and will work with TPMS systems. The 7-1/2" hose length is going to supply you…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 7

To determine the size of the hub assembly you need to purchase you have to determine which bearings are in the old assembly. If the old assembly has L44649 inner bearings, you would use the hub you chose #8-258-5UC1. If the inner bearings are marked…

view full answer...

Answer 8

A BT8 spindle would have a diameter of .99 of an inch where the bearings would both install and would have a diameter of 1.24 where the great seal would ride. That would require a hub part #AKIHUB-440-2-1K for an idler hub. A BTR spindle would have…

view full answer...

Answer 9

To determine the size of the brake assemblies you need you have to measure the depth and width of the hub drum on the axle like what you see in the picture I attached. The most common size is 2-1/4 inch wide like the #T4071600-500 that you…

view full answer...

Answer 10

To find the load capacity for your axle you should look on the trailer VIN plate or sticker that lists the VIN number. The weight rating of the axle should be listed on that same plate or sticker. Also, the axle could have a tag or plate on it that…

view full answer...

How Long are the Hoses in Wheel Masters 2-Hose Inflation Kit WM8007

Product Page this Question was Asked From

Continue Researching