bing tracking image
Q & A Icon

Troubleshooting Tekonsha Prodigy P2 Brake Controller Flashing C And Truck Not Starting  

Question:

I installed a Prodigy 2 on my Ford F150 as soon a I plug in the wires there is a flashing C and it is not connected to my truck and then my truck wont start. Im not sure where this issue is coming from your suggestions would be appreciated thank you.

0

Expert Reply:

The flashing C on your Tekonsha Prodigy P2 Trailer Brake Controller # 90885 sounds like there is corrosion on the brake output circuit of your vehicle 7-way. When the controller detects a load on the circuit (typically from the trailer brake magnets) it will say that it is connected to a trailer even if it is not. Corrosion can cause a slight short on the circuit which then can trick the controller into thinking there is a trailer connected. The slight short causes a small draw on the circuit that the brake controller reads as a connected trailer.

I would recommend cleaning the pins of your trailer 7-way with some fine grit sandpaper and that particular problem should go away. I have attached a help article on brake controller troubleshooting for you to check out for additional help.

The issue with your battery sounds like a battery issue and is most likely not connected to the brake controller. Your battery may need to be more fully charged or replaced.

expert reply by:
0
Jason S

Product Page this Question was Asked From


Q & A Icon

Continue Researching

See More Q&A Expert Answers >>