Will Brake Mounting Flanges be Installed on New Axle
Question:
I have new 6000 lb axles coming for my 99 float-on trailer hauls 27foot world cat catamaran. Would like to put kodiac disc brakes on it. Do new axles come with correct mounts as a rule? Also do you think a new master cylinder is necessary? Dico model 10, original to the trailer.
asked by: Richard B
Helpful Expert Reply:
Whether the axles have the brake mount flanges on them will depend on what you purchased. However, since they're 6,000 pound axles it's fairly likely the flanges will be there. If not, we carry # 4-44-1 for 6,000 pound axles. It will need to be welded to the axle at a trailer shop because it needs to be perfectly square and concentric.
As long as your current brake actuator is for disc brakes and functioning properly there's no need to replace it. However, if you previously had drum brakes it will need to be replaced. Disc brakes operate at a higher pressure than drum brakes. Our most popular actuator for disc brakes is the Titan # T4750620.
If you also need a brake line kit I've linked our selection that works with disc brakes for you.
Products Referenced in This Question
Dexter Zinc-Plated Brake Actuator w/ Drop, Electric Lockout - Disc - 2-5/16" Ball
- Brake Actuator
- Surge Brake Actuator
- Straight Tongue Coupler
- Bolt-On
- 12500 lbs GTW
- 2-5/16 Inch Ball Coupler
- Disc Brakes
- Electric Lockout
- Dexter
more information >
Product Page this Question was Asked From
Brake Mounting Flange for 3" Round Axle
- Accessories and Parts
- Trailer Brakes
- Disc Brakes
- Electric Drum Brakes
- Hydraulic Drum Brakes
- Brake Mounting Flange
- 12 Inch
- 3 Inch Diameter Axle
- Redline
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Shop: Demco Hydraulic Brake Actuator w Drop and Electric Lockout - Disc - Zinc - 2-5/16" Ball - 16K
- Shop: Dexter Zinc-Plated Brake Actuator w/ Drop, Electric Lockout - Disc - 2-5/16" Ball
- Video: Titan Brake Actuator - Surge Brake Actuator - T4750620 Review
- Article: Adding Electric Over Hydraulic Disc Brakes
- Q&A: Recommended Replacement for Atwood Surge Brake Actuator 85778
- Q&A: Adding a 7-Way Trailer Wiring Harness to a 2008 Ford E-150 Van with Factory 4-Way
- Q&A: Availability Of 12" Replacement Brakes For Kelsey Hayes 4-Bolt Pattern With 3-1/2" Center Hole
- Article: Parts Needed to Add Electric Drum Brakes to a Trailer
- Q&A: Adding Brakes to a Mobile Home Axle
- Q&A: Recommended 12 X 2 Electric Trailer Brakes to Replace Hadco Assemblies
- Article: Trailer Drum Brakes vs. Disc Brakes: Making the Decision
- Q&A: Brake Flange Needed to Install 12 Inch Brake Assemblies With 5 Bolt Mounting Holes
- Q&A: How to Determine Weight Capacity of Trailer Axle
- Article: Trailer Wiring Diagrams
- Article: Routing the Power Wire for a Trailer Wiring Harness
- Article: Most Popular Wheel Bearings
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)