Steel Thickness for A-Frame Trailer Jack Support Plates for 2-1/4 Inch Jacks
Question:
How thick are the different Support Plates for 2-1/4inch A-Frame Trailer Jacks that you offer?
asked by: Jon S
Expert Reply:
The A-frame trailer jack support plates for 2-1/4 inch jacks are all approximately 1/8 inches thick. There are some manufacturer tolerances so one might be slightly thicker than the next. And models that are raw steel like # BD003135 are more uniform in size compared to the ones that are powder coated. I have included a link to the options. Not all of them are for 2-1/4 inch jacks and there is also a square one in there but the majority are for 2-1/4 inch round jacks.
Products Referenced in This Question
Bulldog Jack Support Plate - A-Frame - 2-1/3" Diameter Hole
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Mounting Hardware
- Plates
- Bulldog
more information >
Product Page this Question was Asked From
Bottom Support Plate for 2-1/4" OD A-Frame Jacks - 5,000 lbs
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Mounting Hardware
- Plates
- etrailer
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Shop: Bright Way Push-to-Test Trailer Breakaway Kit with 1-Amp Charger and 5 Ah Battery - Top Load
- Shop: Round, Pipe Mount Swivel Jack w/ Footplate - Weld On - Sidewind - 10" Travel - 3,000 lbs
- Q&A: What Are the DOT Requirements for License Plate Lights
- Video: Hopkins Trailer Breakaway Kit - Kit with Charger - 20400 Review
- Shop: Bulldog Jack Support Plate - A-Frame - 2-1/3" Diameter Hole
- Shop: Bottom Support Plate for 2-1/4" OD A-Frame Jacks - 5,000 lbs
- Shop: Hopkins Engager Push-To-Test Trailer Breakaway Kit with Built-In Battery Charger - Top Load
- Shop: 36" Long Safety Chain with 1/4" S-Hook with Latch - 5,000 lbs - Qty 1
- Shop: Optronics LED Trailer Tail Light - Stop, Turn, Tail - Submersible - 10 Diode - Oval - Red Lens
- Search Results: 322~rdj~2k
- Q&A: How to Tell if an Enclosed Trailer Has Rain Gutters
- Search Results: trailer jack mounting plate
- Q&A: Recommended A-Frame Jack Mounting Support Plate For Standard 3 Inch On Center Mount
- Q&A: Installing 322-RDJ-2K Ultimate Trailer Jack
- Q&A: Length of Jack Handle On Ultimate Trailer Jack # 322-RDJ-2K
- Q&A: Do All A-Frame Trailer Jacks Use the Same Mounting Pattern and Center Hole
- Q&A: Is a Support Plate Needed When Installing Bulldog A-Frame Trailer Jack # BD1550101344
- Search Results: ultimate trailer jack
- Search Results: stableload
- Search Results: torklift stable load a7310
- Video: etrailer Trailer Jack JSP-100 Review