Could a Curt Trailer Hitch Receiver # 11074 Tow a Trailer and Motorcycle that Weighs 1,050 lbs
Question:
I have a 2008 vw rabbit.Just wondering if this hitch would be capable of towing a rental motorcycle trailer weighing 550 lbs with a bike that weighs around 500 lbs?
asked by: Allen N
Expert Reply:
Yes, this Curt Trailer Hitch Receiver with Drawbar, part # 11074, that you referenced will work on your 2008 VW Rabbit and has a towing capacity that is higher than the weight of the rental trailer and motorcycle.
You will want to check with the owners manual of your Rabbit also to make sure that it has the towing capacity to tow that much weight.
When determining what your overall towing capacity is for your setup you should always go with the lowest capacity of all the components as the overall capacity.
I attached installation instructions below also for you to check out.
You may also be interested in purchasing the following products also:
Tow Ready Wiring, part # 119250KIT (see video and instructions below)
Hitch Ball with 2 inch Diameter and Medium Shank, part # A-82
Hitch Ball with 1-7/8 inch Diameter and Medium Shank, part # A-80
Products Referenced in This Question
ZCI Circuit Protected Vehicle Wiring Harness w/ 4-Pole Flat Trailer Connector and Installation Kit
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- Converter
- Universal Fit
- 4 Flat
- Tekonsha
more information >
1-7/8" Hitch Ball - 3/4" Diameter x 2-1/8" Long Shank - Stainless Steel - 2,000 lbs
- Trailer Hitch Ball
- Trailer Hitch Ball
- Standard Ball
- Stainless Steel
- 1-7/8 Inch Diameter Ball
- 2-1/8 Inch Shank Length
- 3/4 Inch Diameter Shank
- 2000 lbs GTW
- Class I
- Class II
- CURT
more information >
2" Hitch Ball - 3/4" Diameter x 2-1/8" Long Shank - Stainless Steel - 3,500 lbs
- Trailer Hitch Ball
- Trailer Hitch Ball
- Standard Ball
- Stainless Steel
- 2 Inch Diameter Ball
- 2-1/8 Inch Shank Length
- 3/4 Inch Diameter Shank
- 3500 lbs GTW
- Class I
- Class II
- CURT
more information >
Product Page this Question was Asked From
Curt Trailer Hitch Receiver - Custom Fit - Class I - 1-1/4"
- Trailer Hitch
- Custom Fit Hitch
- Class I
- 200 lbs TW
- 2000 lbs GTW
- 1-1/4 Inch Hitch
- Visible Cross Tube
- CURT
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Why is a Stabilizing Strap Recommended on Curt Hitches and what is Meant by Non-Trailer Load
- Article: Trailer Wiring Diagrams
- Article: My Trailer Hitch Doesn't Fit
- Q&A: What is the Difference Between Class 1 and Class 2 Hitches for the Scion XB
- Q&A: How to Prevent Exhaust Components from Contacting the Trailer Hitch
- Article: How to Correct Noise from Exhaust Rattling Against a Trailer Hitch
- Q&A: How To Order Replacement Hardware Kit For Curt Trailer Hitch
- Article: How to Install a Trailer Hitch
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Q&A: Recommended Replacement for Atwood GCH6A-10E RV Water Heater
- Q&A: Troubleshooting and Fuse Location on Furrion Over the Range RV Convection Microwave
- Article: Trailer Hitch Installation Tips
- Article: What Do I Need To Tow A Trailer?
- Article: Roof-Mounted Watersport Carriers