Recommended Additional Step For RV When Fold Out 3-Step Isn't An Option Based On Measurements

Question

Question:

I just went out again and 26inch is max. I could do a 25 1/2 but nothing over 26 is going to fit. The unit door is to the edge and without major over hauling, over 26 wont work. If you have a 25inch wide one, Ill give a look see at it. 3 step down.

asked by: John M

0

Expert Reply:

We don't have a RV 3 step that is within your measurement of 25-1/2 inches, but I do have another option for you. I recommend the Adjustable-Height, Folding Platform Step - Steel - 24" Long x 16" Wide - 300 lbs # S-150. This adjustable folding step with grip allows you to add the additional step and will allow you to have a stable step even on unlevel ground.

expert reply by: Jason S

0

Answer 1

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 2

When it comes to choosing between the Blue Ox Patriot #BLU37TR and the Brake Buddy Select 3 #HM39524, these systems are extremely similar in their setup and functionality. Both of these systems provide proportional braking in a compact and easy to…

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

Hey Ken, so the first thing you will need is a base plate kit like the Blue Ox part #BLU85CR which fits your 2023 GMC Canyon and would be compatible with your Blue Ox tow bar. I do not know what braking system you had in the past but for a permanent…

view full answer...

Answer 5

Sure thing, I will go ahead and list out what you need for your 2023 Kia Sportage to add a 7-way for a brake controller so you can tow with the Curt Trailer Hitch Receiver #C94WR: - T-Connector Vehicle Wiring Harness with 4-Way Flat Trailer Connector…

view full answer...

Answer 6

Both the Roadmaster and Blue Ox tow bars are great options. But if it was my decision to make I would go with the Blue Ox Avail part #BX7420 as we have found that the Blue Ox tow bars are a little easier to connect and disconnect from. Also this tow…

view full answer...

Answer 7

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 8

The first thing you will need for your 1999 D250 is a 4-way. The Curt T-Connector Vehicle Wiring Harness #C55317 plugs into the connection points behind your rear bumper and will allow you to power your trailer's signal lights. Once the 4-way is…

view full answer...

Answer 9

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 10

Hey John, we actually have a supplemental braking system that was designed specifically to be used with the Spartan K2 chassis you have that has the Safe Haul system with the Demco Air Force One Flat Tow Brake System part #DM54YV so this would be the…

view full answer...

Answer 11

For sag from towing a trailer the best recommendation I can make is actually a weight distribution system. Suspension enhancement will help level your truck while towing. But the advantage to a weight distribution system is that it levels the vehicle…

view full answer...

Recommended Additional Step For RV When Fold Out 3-Step Isn't An Option Based On Measurements

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching