Trailer Light Recommendation for 84 inch Wide Trailer

Question

Question:

I have an 18foot trailer that is 84inch wide. The existing lights are 88inch center to center apart. Which of your lights would accommodate this trailer?

asked by: Dusty

0

Expert Reply:

For a trailer lighting kit designed for the requirements of trailers that are over 80 inches in width we have the Optronics kit part # TL16RK which would work well. It comes with submersible taillights as well as a couple amber clearance lights.

expert reply by: Jameson C

0

Answer 1

We do have an over 80 inch LED trailer taillight kit that's submersible and would work great on your 1998 Shorelandr boat trailer as the part #TL16RK. This comes with the LED taillights you want, clearance lights, license plate bracket and…

view full answer...

Answer 2

The LED Combination Trailer Tail Light part #STL14RB would be a suitable replacement for the passenger side tail light on a 2019 Bass Tracker Trail Star Trailer. If ever needed, we also have part #STL15RB for the driver side.

view full answer...

Answer 3

That is a great question, I have a solution for you below: **Miro-Flex LED Combination Trailer Tail Lights - Submersible #STL28RB & #STL29RB. Not knowing the exact light you have and based off of your information given the light is either water…

view full answer...

Answer 4

The "80" you are referring to is the width of the trailer, and it makes it easier to determine the light kit you need. Since you need tail lights as well as running lights, I recommend the Trailer Light Kit for Trailers Over 80" Wide…

view full answer...

Answer 5

Yes, the Peterson LED Identification Light Bar #M191-3RL that you referenced would work great on your 2005 Nitro boat trailer as this is submersible and universal enough that it can easily be made to fit a boat trailer like yours.

view full answer...

Answer 6

A trailer that is over 80 inches wide is required by DOT regulations to have rear clearance lights. An over 80 inch taillight kit, like part #TL16RK, will have the side clearance light built into it. An under 80 inch taillight does not have the…

view full answer...

Answer 7

You will need the Red LED Trailer Clearance or Side Marker Light #328-K-52 or Amber LED Trailer Clearance or Side Marker Light #328-K-51 for your 2018 Forest River Sunseeker motorhome. These lenses have the same Top Command SAE-AP2-16 markings on the…

view full answer...

Answer 8

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 9

I've never heard of an actual third brake light connector on a camper shell to plug in on a truck and we don't carry any parts to do that. The light generally needs to be hardwired into the truck's brake light circuit. The issue with this…

view full answer...

Answer 10

If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…

view full answer...

Answer 11

If the trailer wheels scrubbed (dragged and scrapped the ground instead of rolling) when jack knifed then it could have thrown something out of alignment or damaged something. First, inspect the suspension. Look for any elongated holes where…

view full answer...

Answer 12

I would be happy to help you set up your 2022 Toyota Highlander to haul your new travel trailer. The wiring harness you currently have controls your trailer's lighting functions only. You do not need to rewire your Toyota you just need another…

view full answer...

Trailer Light Recommendation for 84 inch Wide Trailer

Product Page this Question was Asked From

Continue Researching