Is the Starter Solenoid PK5231201 Continous Duty

Question

Question:

IS THIS SOLENOID truly continuous duty? In other words can it be on for hours at a time without overheating or burning out?

asked by: Charles

0

Expert Reply:

Yes, the solenoid part # PK5231201 is continous duty and can be in use for long periods of time without burning out.

expert reply by: Jameson C

0

Answer 1

The Bulldog Winch OE Replacement #BDW20088 is wired so that two separate outputs can be run from a vehicle battery, but this is a continuous duty solenoid, so it's not going to operate in the manner that you're hoping. With that being said, I…

view full answer...

Answer 2

You wouldn't want to submerge the Starter Solenoid part #PK5231201 but it is water resistant. In an outside application though it would be fine.

view full answer...

Answer 3

The Starter Solenoid #PK5231201 draws 100 amps.

view full answer...

Answer 4

A solenoid that has 3 terminals total such as #PK5231201 grounds through the mounting hardware so it must be attached to a clean and corrosion free bare metal surface (if not otherwise internally grounded). A 4 terminal solenoid such as #PK5230701…

view full answer...

Answer 5

I can't help you with the power adapter for your older backup camera since we never carried that part, but I can help you make it so the tow vehicle you have won't continue to charge a trailer's battery when the vehicle is turned off to…

view full answer...

Answer 6

The Lippert Replacement Reverse Polarity Solenoid for RV Hydraulic Slide-Outs part #LC136046 and part #LC118246 are the same solenoid but vary in how they mount. The part #LC136046 mounts using a strap around the motor like what you have therefore…

view full answer...

Answer 7

Thank you so much for all of the info! The Battery Isolation Solenoid #PK5231201 does serve it's purpose but I do understand the need for something that is able to do a bit more. The best solution that we have to offer is the Redarc Smart Start…

view full answer...

Answer 8

Basically the Pollak wires in line with where power needs to be transferred. So if you were using this as a starter solenoid the power wire that runs to the starter would have this ran inline on the bigger terminals and then the smaller terminal is…

view full answer...

Answer 9

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 10

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 11

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...

Answer 12

Another wire or harness is not needed on the 2023 Honda CR-V for the install of the Curt 4-Way Wiring Harness #C56370, but you do have to add 20 amp fuse to location #17 in the fuse box.

view full answer...

Is the Starter Solenoid PK5231201 Continous Duty

Product Page this Question was Asked From

Continue Researching