Replacement Wheel Cylinder For Dexter 12-Inch Hydraulic Drum Brake Assembly

Question

Question:

What is the appropriate replacement wheel cylinder for a 023-342-00 brake assembly? Thanks

asked by: Dan M

0

Expert Reply:

The replacement wheel cylinder that will work with your Dexter # 23-342 left hand brake assembly is part # AKBRKR-H7-L-CR.

If you need a replacement wheel cylinder for the right hand side you need part # AKBRKR-H7-R-CR.

expert reply by: Jeffrey L

0

Answer 1

The two wheel cylinders you mentioned #T0977600 and #T0977600 are mirrored versions of each other. The part #T0977700 fits the left hand side and the #T0977600 fits the right hand side. They are not interchangeable.

view full answer...

Answer 2

The coupler you are seeking is a surge brake coupler. You may not have the same look as your previous coupler as styles can change, but you need to make sure you have the correct capacity rating for your trailer and the correct coupler as drum…

view full answer...

Answer 3

Hey Richard, thanks for reaching out! The Dexter DX7.5 Drop-N-Go Brake Actuator #099-175-00 is a great option for a replacement actuator because it's a direct replacement for the common Model 60 actuators that were popular in the…

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

The manual lockout on your Atwood 85778 surge brake coupler is there so that you can back up the trailer without the brakes locking up on you. Yes you can safely tow your trailer with the broken manual lockout, you just have to make sure you…

view full answer...

Answer 6

Traditionally, trailer manufacturers did not use electric brakes on boat trailers because the brake magnet wiring and trailer wiring did not always have the best insulation or water protection. These days, more and more manufacturers are using…

view full answer...

Answer 7

I currently have three diffrent self-adjusting assemblies for your boat trailer with 10" x 2-1/4" electric drum brakes which are attached for you below. eTrailer Electric Trailer Brake Kit part #AKEBRK-35-SA (3,500 Axles) Dexter…

view full answer...

Answer 8

The biggest difference between the servo styles that you'll notice is between free backing plates and the others. The free-backing plates will allow your trailer to back up without having the brakes lock up. With surge brakes typically when you…

view full answer...

Answer 9

Hey Kevin, for your Demco DA70 actuator you can use the Reverse Lockout Solenoid for Demco Hydraulic Brake Actuators #DM11993.

view full answer...

Replacement Wheel Cylinder For Dexter 12-Inch Hydraulic Drum Brake Assembly

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching