Could Kayak Rack Foam Pad Attach to the Naked Roof of a Fifth Wheel

Question

Question:

I want to carry two 13foot kayaks on the roof of my Grand Design Reflection 337RLS. This looks like it might work. However, I dont quite see how the kayak straps are attached to the Fifth Wheel. Can you give me some more information? The trailer has a ladder, but no roof rack. Any chance you have pictures or videos of a completed installation?

asked by: Jeff C

0

Expert Reply:

The Rightline Gear Kayak Rack part # RL100K10 is designed to fit naked roofs of vehicles. It may still work on the roof of your fifth wheel but you should note that the strap lengths are only 12 feet and the S-hooks of the straps may not have a place to attach to on your trailer.

I really think installing this kayak rack on your tow vehicle will be your better option if that's something you were considering. It's going to be very difficult getting the kayaks off and on your trailer and they may even sit too high for low clearance situations.

expert reply by: Jameson C

0

Answer 1

The Replacement Amber Lens for MC32AB Trailer Lights #A32AB is a direct replacement for the Sae-a-p2-dot-14 that measures 4" L x 2" W x 1/2" H. A red lens replacement with the same dimensions is the LED Trailer Clearance or Side Marker…

view full answer...

Answer 2

Assuming that the kayaks are narrow enough width-wise to safely fit on the roof of the vehicle, using two foam block carriers like part #RL100K10 would be an option as long as the combined weight of the kayaks doesn't exceed the roof capacity of…

view full answer...

Answer 3

There are no custom fit roof racks that will fit your 2010 GMC Terrain with a naked roof but the good news is you don't have to have one to carry at least one kayak. You can use a foam block system, maybe 2 if the kayaks are narrow enough. Foam…

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 7

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 8

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

view full answer...

Answer 9

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 10

Load range B trailer tires are going to have a lower capacity than C load range tires. Basically that, psi rating, and the ply rating are the only differences. A higher load range tire would last a little longer than lower load ranges of the same…

view full answer...

Answer 11

A BT8 spindle would have a diameter of .99 of an inch where the bearings would both install and would have a diameter of 1.24 where the great seal would ride. That would require a hub part #AKIHUB-440-2-1K for an idler hub. A BTR spindle would have…

view full answer...

Answer 12

You can convert surge brakes to an electric over hydraulic braking system. To do this, you will need an electric over hydraulic actuator and a brake controller. For an electric over hydraulic actuator, I recommend looking at the Carlisle HydraStar…

view full answer...

Could Kayak Rack Foam Pad Attach to the Naked Roof of a Fifth Wheel

Featured Help Information

Miscellaneous Media

Continue Researching