Are the Trailer Taillight Mounting Brackets BK70BB Sold Individually or In Pairs

Question

Question:

If I order this, will I get a pair?

asked by: Steven W

1

Helpful Expert Reply:

The brackets part # BK70BB are sold individually and not in pairs.

expert reply by: Jameson C

1

Answer 1

Yes, it would! The Trailer Light Mounting Bracket item #BK70BB and the LED Light Kit item #98174LED would still be the best way to add a set of lights to a Yakima OnRamp Bike Rack 1-1/4" item #Y96FR. I have attached a picture below that a…

view full answer...

Answer 2

I have a bit of an easier recommendation for you in the Curt Auxiliary LED Indicator Lights #C53201. These lights will simply double sided tape to the frame on your Thule T2 Pro XTR Bike Rack #TH83JV. They are also much lighter and smaller than the…

view full answer...

Answer 3

Although it's intended for a cargo carrier, we have a light kit that work great for you. Part #98174LED provides long lasting LED lamps that use minimal power but are very bright. You'll also need two brackets for the lamps, part…

view full answer...

Answer 4

The Pro Series Cargo Carriers (part #s 63152, 63153, 63154 and 63155) are indeed compatible with the #20174 light kit. An LED version is also available as part #98174LED. LED lamps will draw a fraction of the power of incandescent bulbs, and you will…

view full answer...

Answer 5

You'd have to drill a pretty large hole to fit the plug ends of the #98174LED through the brackets. I'd rather recommend you zip tie the harness to a much smaller hole instead of drilling the roughly 1-1/4 inch hole you'd have to drill,…

view full answer...

Answer 6

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 7

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 8

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 9

To me it makes the most sense to put a Bike Rack #HLY64FR on the flat towed vehicle rather than above the tow bars. Especially on heavy e-bikes as they are difficult to lift that high onto the rack, but also as it only makes sense to have the rack on…

view full answer...

Answer 10

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 11

Hi Robert; hopefully your Roadmaster tow bar is one that attaches to direct-connect base plates as opposed to crossbar base plates; for example the 8,000 lb Roadmaster Sterling would be optimal. Assuming that, here is what you need to flat tow your…

view full answer...

Answer 12

Hi Emily, Before buying anything you'll want to verify that both the Pilot and the trailer hitch installed on it are rated for use with a weight distribution hitch (WDH). From what I can see Honda does not recommend it because it can shift the…

view full answer...

Are the Trailer Taillight Mounting Brackets BK70BB Sold Individually or In Pairs

Product Page this Question was Asked From

Continue Researching