What is the Load Rating of Dexstar Steel Spoke Trailer Wheel, # AM20781

Question

Question:

What is the load rating of this wheel? Thanks.

asked by: Dave C

0

Expert Reply:

According to Americana, the Dexstar Steel Spoke Trailer Wheel, # AM20781, is rated for 3,750 pounds when mounted with a properly sized tire inflated to 110 psi. This 16 inch steel wheel has a galvanized finish, 8 on 6-1/2 bolt pattern, and has a pilot diameter of 4.9 inches.

expert reply by: Michael H

0

Answer 1

When you replace the axles on a trailer you will look at the (A) hub-face-to-hub-face and the (B) spring-center-to-spring-center measurements and choose an axle that has the same measurements that your current axle does. Since you are wanting to…

view full answer...

Answer 2

We offer beam axles and also axle kits that include hubs, bearings and other components. You can view our main page for 89-inch trailer axles using the link provided. The 89-inch dimension is taken from one hub face to the other hub face; these axles…

view full answer...

Answer 3

Often an axle's weight rating will appear on a sticker or plate on the axle beam itself, or sometimes the trailer's main identification sticker will include axle ratings. This is helpful unless of course the axles have been replaced during…

view full answer...

Answer 4

I do have a few easier options for you to determine the weight capacity of an axle other than using the bolt pattern or the number of lug nuts. The problem with using the bolt pattern to tell the axle capacity is that an axle may have the a bolt…

view full answer...

Answer 5

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 6

If you are needing the hub and drum assembly then you will want to go with the Dexter Trailer Hub and Drum Assembly #8-201-5UC3-EZ but if you are just looking for an idler hub then you will want part #8-213-5UC1 instead. These come with the correct…

view full answer...

Answer 7

You will need the Red LED Trailer Clearance or Side Marker Light #328-K-52 or Amber LED Trailer Clearance or Side Marker Light #328-K-51 for your 2018 Forest River Sunseeker motorhome. These lenses have the same Top Command SAE-AP2-16 markings on the…

view full answer...

Answer 8

The old version of the #HBA-CAM used 4 wires, but the product was updated awhile back and now uses only two wires as shown in the photo on the product description page. The white wire from the HBA-CAM would tap into the white ground wire and the blue…

view full answer...

Answer 9

The only way you could power interior dome lights on a trailer without it being connected to a tow vehicle would be to power the lights with a battery like a breakaway battery. How you choose to wire up the batteries will in the end be up to you, but…

view full answer...

Answer 10

I would be happy to help you set up your 2022 Toyota Highlander to haul your new travel trailer. The wiring harness you currently have controls your trailer's lighting functions only. You do not need to rewire your Toyota you just need another…

view full answer...

Answer 11

I've never heard of an actual third brake light connector on a camper shell to plug in on a truck and we don't carry any parts to do that. The light generally needs to be hardwired into the truck's brake light circuit. The issue with this…

view full answer...

Answer 12

Since you have a wheelbase/axle spacing of 38 inches the correct hanger kit for slipper springs would be the part #HAP-105-205-01. And then for a 7k trailer axle the u-bolt kit you'd want would be the part #APUBR-8. I attached the diagram to use…

view full answer...

What is the Load Rating of Dexstar Steel Spoke Trailer Wheel, # AM20781

Product Page this Question was Asked From

Continue Researching